Datasheet

6 Frequency/Rate Meter K3MA-F
Operation
■ Main Functions
Input Types and Ranges
Pulse Frequency Selection
Note: The default value is “0 to 5 kHz (5k).”
Scaling
When the desired display value is set for a corresponding input, the value will be displayed on a line between two points determining the zero point.
Frequency range
(setting parameter)
Function Input range (setting parameters) Setting range
Pulse frequency selection
(p-fre)
Selects pulse input signal. 0.05 to 30.00 Hz (30) Displayable from
−19999 to 99999
with scaling function.
The position of the decimal point
can be set as desired.
0 to 5 kHz (5k)
Parameter Setting value Meaning
p-fre 3 0.05 to 30.00 Hz
measurement range
5k 0 to 5 kHz measure-
ment range
Parameter Setting value Meaning Parameter Setting value Meaning
inp 0 to 99999 Input value for dsp dp %.%%%% Display four digits after decimal point
dsp -19999 to 99999 Display value for inp %%.%%% Display three digits after decimal point
%%%.%% Display two digits after decimal point
%%%%.% Display one digit after decimal point
%%%%% No decimal point
•
The decimal point can be optionally displayed.
Display value
DISPLAY
Input value
INPUT
Teaching with actual values is possible.
Instead of setting by inputting with the Up Key and Shift Key, current values can be
input as scaling input values for teaching. This is useful for making settings while checking the
operation status of the K3MA-F.
Note:
The initial value will change depending on the
pulse frequency selection.
•
When displaying the decimal point, consider the
number of digits to follow the decimal point prior to
setting the scaling display value.
•
If
p-fre
is set to 30, the initial setting for the
decimal display will be
000.00
.