Datasheet

H3CR-F

Specifications

■ General

Note: For details, refer to your OMRON website.

■ Time Ranges

Note: The times that can be set are given. When the time setting knob is turned below “0” until the point where the time setting knob stops, the

output will operate instantaneously at all time range settings.

For details, refer to your OMRON website.

■ Ratings

Note: 1. A power supply with a ripple of 20% max. (single-phase power supply with full-wave rectification) can be used with each DC Model.

2. Do not use an inverter output as the power supply. Refer to your OMRON website for details.

3. Refer to your OMRON website when using the Timer together with a 2-wire AC proximity sensor.

Item H3CR-F H3CR-F8 H3CR-FN H3CR-F8N

Operating mode Flicker OFF start Flicker ON start

Pin type 11-pin 8-pin 11-pin 8-pin

Operating/Reset method Time-limit operation/Time-limit reset or self-reset

Output type Relay output (DPDT)

Mounting method DIN track mounting, surface mounting, and flush mounting

Approved standards UL508, CSA C22.2 No.14, NK, Lloyds, CCC

Conforms to EN61812-1 and IEC60664-1 (VDE0110) 4kV/2.

Output category according to EN60947-5-1.

Time unit s (sec) ×10 s (10 sec) min (min) ×10 min (10 min) h (hrs) ×10 h (10 hrs)

Fullscale

setting

1.2 0.05 to 1.2 1.2 to 12 0.12 to 1.2 1.2 to 12 0.12 to 1.2 1.2 to 12

3 0.3 to 3 3 to 30 0.3 to 3 3 to 30 0.3 to 3 3 to 30

12 1.2 to 12 12 to 120 1.2 to 12 12 to 120 1.2 to 12 12 to 120

30 3 to 30 30 to 300 3 to 30 30 to 300 3 to 30 30 to 300

Rated supply voltage (See notes 1, 2, and 3.) • 100 to 240 VAC 50/60 Hz/100 to 125 VDC

• 24 to 48 VAC 50/60 Hz/12 to 48 VDC

Operating voltage range 85% to 110% of rated supply voltage; 90% to 110% with 12-VDC models

Power reset Minimum power-opening time: 0.1 s

Power consumption 100 to 240 VAC: approx. 10 VA (2.1 W) at 240 VAC

24 VAC/VDC: approx. 2 VA (1.7 W) at 24 VAC

approx. 1 W at 24 VDC

Control outputs Contact output: 5 A at 250 VAC/30 VDC, resistive load (cosφ = 1)

The minimum applicable load is 10mA at 5VDC (P reference value).

Contact materials : Ag-alloy