Datasheet

Screwless Clamp Terminal Socket P2RF@@S 5
■ Wiring
Use wires of the applicable sizes specified above. The length of the
exposed conductor should be 8 to 9 mm.
Use the following wiring procedure.
1. Insert the specified screwdriver into the release hole located
beside the wire connection hole where the wire is to be inserted.
2. Insert the exposed conductor into the wire connection hole.
3. Pull out the screwdriver.
8.5 ±0.5 mm
Fig. 1 Exposed Conductor Length
Fig. 2 Wire Connection Holes and Release Holes
Wire connection holes
Release holes
A
A
Wire connection hole
Fig. 3 Section A-A of Fig. 2
Release hole
Screwdriver
Insert
Insert
Pull out