Datasheet

Products Related to Common Sockets and DIN Tracks
28
Features of Screwless Sockets
Safety Precautions
• Do not move the screwdriver up, down, or from side to side or rotate it while it is inserted in the hole. Doing so may damage internal components in the
Socket.
• Do not insert more than one wire into the same hole. Doing so may cause abnormal heating.
• There are two internally connected wiring holes for each terminal.
• Insert the screwdriver along the hole wall as shown below.
• When you remove a Socket from a support rail, insert the end of a screwdriver into the fixture and move the driver as shown by the arrow in the
following figure.
• When you use a Release Lever to remove a Relay from a P2RF-@@-S Socket, insert a screwdriver at the location shown in the following figure
and move the Release Lever in the direction indicated by the arrow to release the lock on the release lever.
Precautions for Safe Use
Complete Wiring in Three StepsStructured for Easy Wiring
Insert a
screwdriver.
Screwdriver
inserted.
Insert the wire. Remove screwdriver
to complete wiring.
• A spring holds the wire in place to reduce wiring work by
30% (according to OMRON comparison) and eliminates the
need to manage torque.
• DIN terminal numbers also indicated.
Contact terminal
(common)
Coil terminals
Release Lever
(sold separately)
Nameplate
(sold separately)
Contact terminal
(NO)
Contact terminal
(NC)
Screwdriver
Screwdriver
Fixture rail