Datasheet

Products Related to Common Sockets and DIN Tracks
29
Wiring Tools
Applicable Screwdriver
Use a flat-blade screwdriver with a tip that is 2.5 mm wide (3.0 mm
max.).
Applicable Screwdriver (Example)
VESSEL No.9900 − (−) 2.5 × 75
Applicable Wires
• You can use either solid wires or stranded wires. Applicable wire
size: 0.2 to 1.5 mm
2
(AWG24 to AWG16)
• Strip 8 to 9 mm of insulation from the ends of the wires.
• If you insert stranded wires without ferrules, make sure that the
wires are twisted when you insert them.
• If you use bare ferrules, always attach insulating sleeves.
• If you insert a wire with a sheath outer diameter of 2.2 mm or less,
do not insert the wire far enough so that the sheath is engaged
inside the hole, as shown below.
• Two wires with a sheath outer diameter of 3.2 mm or larger cannot
be inserted for the same terminal at the same time.
• Use heat-shrinking tubes to indicate wire numbers.
Precautions for Correct Use
2.5 mm (3.0 mm max. )
Yo u cannot use a screwdriver with a thick shaft.
8 to 9 mm