User's Manual

Section 5 Chemical Resistance of Tags

RFID System

User’s Manual

Section 5

Chemical Resistance

Applicable Model

PPS resin is used for case material and epoxy resin for filling material. Refer to the following lists and do not

use chemicals that affect PPS and epoxy resin.

 Chemicals That Cause Deformations, Cracks, Etc.

 Chemicals That May Cause Discoloration, Swelling, Etc.

 Chemicals that Do Not Affect PPS Resin or Epoxy Resin

Note: The above results are from tests conducted a room temperature (23°C). Even if the chemicals

do not affect the PPS or epoxy resins at room temperature, they may affect the resins at higher

or lower temperatures. Check the chemicals carefully in advance.

V680-D1KP52MT

PPS resin Epoxy resin

Aqua regia Aqua regia, chromic acid, sulfuric acid (90% RT),

nitric acid (60% RT), ammonia solution, acetone,

methylene chloride, phenol

PPS resin Epoxy resin

Nitric acid (60% RT) Sulfuric acid (10% RT), nitric acid (10% RT), hydrochlo-

ric acid (30% RT), acetic acid (50% RT), oxalic acid,

calcium hydroxide, benzine, creosol, alcohol, cyclohex-

ane, toluene, xylene, benzine, grease

PPS resin Epoxy resin

Hydrochloric acid (37%RT), sulfuric acid (98%RT),

nitric acid (40%RT), Hydrogen fluoride solution

(40%RT), chromic acid (40%RT), hydrogen peroxide

(28%RT), sodium hydroxide solution (60%RT),

ammonia solution (28%RT), sodium chloride (10%RT),

sodium carbonate (20%RT), sodium hypochlorite,

phenol solution (5%RT), glacial acetic acid, acetic acid,

oleic acid, Methyl alcohol (95%RT), ethyl alcohol

(95%RT), Ethyl acetate, sebacic acid, diethylhexyl,

acetone, diethyl ether, n-heptane, 2-2-4 trimethylpen-

tane, benzine, toluene, aniline, mineral oil, gasoline,

insulating oil, dichloroethylene, carbon tetrachloride

Ammonia, hydrochloric acid (10% RT), potassium

hydroxide, petroleum, gasoline, Yushiroken S50,

Chemi-Cool Z, Velocity No. 3, Yushiroken EEE-30Y,

methyl ethyl ketone, sodium hydroxide (10%RT)