Controller Link Units Operation Manual

37
Data Links Procedures Section 2-1
• 1:N allocation (Compatible with CS1W-CLK21-V1 and CJ1W-CLK21-
V1)
Common Type
Note For automatic data link creation with 1:N allocations, use the CX-Net
in CX-Programmer version 3.2 or higher.
Contents Method Nodes Page
a. Set the data link mode
to automatic.
Use Support Soft-
ware for the PLC
including Program-
ming Console (see
note).
Data link startup node
only
The node that is used
to start the data link is
called the startup
node. It is necessary
to decide beforehand
which node will be
the startup node.
113
b. 1:N setting Data link startup node
only
134
Area
1
c. Set the area
Data link startup node
only
Only when Area 1 is
used
d. Set the data
link start word
e. Set the num-
ber of send
words per mas-
ter node
f. Set the num-
ber of send
words per slave
node
Area
2
g. Set the area
Data link startup node
only
Only when Area 2 is
used
h. Set the data
link start word
i. Set the num-
ber of send
words per mas-
ter node
j. Set the num-
ber of send
words per slave
node
k. Set the first data link
status word
Data link startup node
only
l. Set the nodes to par-
ticipate in the data
links.
Data link startup node
only