User Guide

10
How to Measure Blood Pressure
2. Measurement is over and blood pressure values and
pulse are displayed.
When the measurement is over, a mark flashes, and the cuff
deflates automatically. Then a mark turns on and blood
pressure and pulse rate are displayed simultaneously.
* If a measurement cannot be made or the blood pressure values are
displayed abnormally high (low), refer to Page 15.
* If the Velcro tape comes off during the measurement, wrap the wrist cuff
snugly as shown in Page 7 and measure again after fastening the Velcro
tape.
3. Turn off the power.
Blood pressure measurement is complete now.
Press the START/STOP button to turn off the power.
To make another measurement, repeat the procedure in Step 1
above.
* Even if you forget to turn off the
power, the monitor will turn off
automatically in approximately 2
minutes.
Display of measurement results
Pulse
Systolic Blood Pressure
Diastolic Blood Pressure
OMRON-R5 (Eng) 11/27/03 10:48 AM Page 10