Use and Care Manual

Vertical plank installation
Horizontal plank installation
Adhere first plank to adhesive pads
and lock in place with Plank Holder
3/8” (1cm)
Cut tongue off
first planks.
Use spacers to space 3/8” (1cm) from floor & wall
Make sure planks stay plumb or
level throughout installation.
PAGE 2
Use drill guide to hold planks in
place during installation.
Do not allow gaps behind planks
Install start/stop clip then
add adhesive pads.
Ensure the
back sides
of all
planks are
free of dust
and debris.
Groove
sides of
planks
must be
placed
facing the
correct
direction,
ready to
interlock
with the
next
plank.
Install connection clips after each plank to secure planks to
every rail, so planks do not come loose or buckle.
NOTE: Groove side of plank orientation - See page 1
Make sure planks are flush against rails.
When finished installing all planks,
use finish razor to remove the
exposed portion of each tab.