Congratulations! On your purchase of our 911 Emergency Phone, you have received our new standard of excellence.
Installation instructions: Please read instructions in its entirety prior to installation. Notice: We recommend that you check your American Disabilities Act (ADA) and State Health and Safety codes before installation to insure proper placement and city, county compliance. 1. Determine how your landline phone line or cellular transformer power line will be routed to the 911 phone. You have three options: A.
B. If line is being routed from above or below 911 phone, the back plate should be fastened to the structure using proper ¼” fasteners. The conduit should be fastened to the structure overlapping the back plate to the large center hole. Pull two (2) feet of line through back plate to attach to circuit board on faceplate. 3. Installing Red Housing A. Remove faceplate from the inside of red housing. B. On the backside of the red housing, puncture plastic plug.
B. Instructions for Landline Faceplate: ( SEE PHOTOS BELOW ) Remove insulation off the end of the two (2) wires exposing 3/8” of copper wire to deliver the dial tone. Fasten one to the left side and the other wire to the right side of the green removable dial tone adapter. After installing wires to the adapter, check for dial tone on the handset, then proceed with installing faceplate into red housing with the four (4) faceplate screws. 5.
CELLULAR PRE-RECORDING ADDRESS INFORMATION & TESTING WHEN RECORDING PLAYS A. Insert SIM card into the SIM card slot located on bottom left corner of cellular circuit board. B. Make sure both antennas are pointing straight up, then tighten at the base. 1. HANDSET ON HOOK – Standing by 911 Phone location, Plug in battery – The red power bulb on the bottom right corner of circuit board will light up – wait until the lower green bulbs quit flashing, Proceed to step # 2. 2.
6. MOVE DIP SWITCH 4 BACK TO “ON” POSITION 7. HANDSET OFF HOOK a. Press red button to hear location address b. Listen to the recording c. If the recording is bad? Repeat - step # 4, 5, & 6. d. Your recording is good! Proceed to step # 8 8. HANDSET ON HOOK 9. Wiring Transformer Power Wires to Circuit Board: (SEE PHOTO 12. BELOW) Remove insulation on three (3) wires exposing ½” of copper wire. Ex: Green goes to GRD, blue solid goes to DC +, and white with blue line goes to DC –.
11. Testing Your 911 “Cellular” Emergency Phone: Dial 911. When the emergency operator answers, within 3 to 5 seconds, the Voice Caller ID Recording will play. Both parties will hear the recording in full, without interruption, after recording ends your conversation can follow. 12. Removal Power Terminal 12. DC- DC+ + Grd. On Guard, Inc. 13. DC+ GRD DC- * ( 713 ) On Guard “664-8273” * www.onguard.