User Instructions

4
B. If line is being routed from above or below 911 phone, the back plate should be fastened to
the structure using proper ¼” fasteners. The conduit should be fastened to the structure
overlapping the back plate to the large center hole. Pull two (2) feet of line through back
plate to attach to circuit board on faceplate.
3. Installing Red Housing
A. Remove faceplate from the inside of red housing.
B. On the backside of the red housing, puncture plastic plug. Insert line through plastic plug,
then fasten red housing to back plate using the four (4) housing screws and washers.
4. Installing Faceplate:
A. Remove ID card by loosening four (4) nuts and sliding out. Provide detailed location
information with nonfading label maker providing address and the location of the pool
(For example: 1234 Way St., Pool by Bldg. 5, City, State, Zip).
Reinstall ID card with clear lens on top for ID card protection.
Attention: If you are installing a Cellular Emergency Phone
Go to Page 6 and continue with Cellular Pre-Recording Address Information
Otherwise proceed to Page 5 to complete your installation of your Landline Faceplate.