User Instructions

7
6. MOVE DIP SWITCH 4 BACK TO “ON” POSITION
7. HANDSET OFF HOOK
a. Press red button to hear location address
b. Listen to the recording
c. If the recording is bad? Repeat - step # 4, 5, & 6.
d. Your recording is good! Proceed to step # 8
8. HANDSET ON HOOK
9. Wiring Transformer Power Wires to Circuit Board:
(SEE PHOTO 12. BELOW) Remove insulation on three (3) wires
exposing ½” of copper wire. Ex: Green goes to GRD, blue solid
goes to DC +, and white with blue line goes to DC –.
“Write down which wire color is attached to locations, GRD,
DC+ and DC-.” Insert
panel, tip right side in first followed by left. Install (4) faceplate screws.
10. Wiring transformer:(SEE PHOTO 13. BELOW) Using the same wire color and locations that
were used on the circuit board setup, repeat this on transformer. Plug in transformer. A red
blub will light up on the front side of the transformer when you have power from the
receptacle, also a power bulb will light up next to the power terminal showing power from the
transformer is being received.