User Manual Owner manual

Advanced Settings

N300 WiFi ADSL2+ Modem Router (N300RM)

In this case you have to define a static route, telling your modem router to access

134.177.0.0 through the ISDN modem router at 192.168.0.100. In this example:

• The Destination IP Address and IP Subnet Mask fields specify that this static route

applies to all 134.177.x.x addresses.

• The Gateway IP

Address field specifies that all traffic for these addresses should be

forwarded to the ISDN modem router at 192.168.0.100.

• A metric value of 1 works since the ISDN modem router is on the LAN.

• Private is selected only as a precautionary security measure in case RIP is activated.

 To set up a static route:

1. Select Advanced > Static Routes, and click Add to display the following screen:

2. In the Route Name field, type a name for this static route (for identification purposes only.)

3. Select the Private check box if you want to limit access to the LAN only

. If Private is

selected, the static route is not reported in RIP.

4. Select the Active check box to make this route ef

fective.

5. T

ype the destination IP address of the final destination.

6. T

ype the IP subnet mask for this destination. If the destination is a single host, type

255.255.255.255.

7. T

ype the gateway IP address, which has to be a modem router on the same LAN segment

as the modem router.

8. T

ype a number from 1 through 15 as the metric value.

This value represents the number of modem routers between your network and the

destination. Usually

, a setting of 2 or 3 works, but if this is a direct connection, set it to 1.

9. Click Apply to add the static route.