Drawing

ManualsBrandsOn-Q ManualsCables & installationHolds On-Q modules and other gear

Page 3 of 4

INSTRUCTION/INSTALLATION SHEET

Core Line Enclosure with Cover

IS-0366 REV. C

Figure 4

C. Other Cable Rough-In

1) For local area network (LAN) and other data connections, install Category 5e cable from the enclosure to the

desired outlets.

2) For Audio and other low voltage applications, install appropriate cable per the application instructions.

D. Security and Control Wiring (Control Wiring is low voltage wiring which controls lighting and other household

systems):

1) Install security and control cabling from the enclosure to the sensors and devices being controlled. Route

the cable through the enclosure access holes with approximately three feet of excess. Label cables near the

entry into enclosure and at outlet location.

Note: Refer to Security System installation guide for cable requirements and marking.

5. Screw–on Cover Installation

NOTE: Only use On-Q/Legrand Covers with the enclosure.

Covers must be matched to the proper size enclosure.

A. Partially install the top two (2) screws in the enclosure.

B. Hang the screw-on cover on the two partially installed screws

using the keyhole openings in the cover. The cover should

hang freely and fit up against the enclosure; if not, check to

see if cables are outside the enclosure or check to see if

cables are being pinched.

C. Install the remaining two screws with lock washers, and

tighten.

D. Remove the top two screws and reinstall with lock washers.

Tighten the screws.

NOTE: Screws must be installed with lock washers to ensure proper

cover grounding. The screws and lock washers must be installed to

ensure the cover is electrically grounded to the enclosure.

(See Figure 4)

NOTE: READ AND UNDERSTAND ALL INSTRUCTIONS

Follow all warnings and instructions marked on product. For use only with compatible products. Follow

manufacturers installation instructions for all modules and support products

6. Hinged Cover Installation

A. Partially install two(2) hinged cover mounting screws in the top two holes

on the enclosure (see Figure 5).

B. Hang the hinged cover on the two partially installed screws using the

keyhole openings on the hinge. The cover should fit up against the

enclosure (surface mount) or the wall(recessed mount). If the cover does

not fit properly, check that the cables are not being pinched, or that the lock

is not in the locked position.

C. Install the remaining hinge screws with lock washers.

D. Remove the top two screws and reinstall with lock washers. Tighten the

screws.

E. Lock hinged cover if desired.

Hinged Cover Assembly

Figure 5