Owner's Manual
Table Of Contents
onoQ
Dlegrancf
301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343
f Fax (717) 702-2546
www.onqlegrand.com
INSTRUCTION I INSTALLATION SHEET
Home
Entertainment
Connection
Center
(HECC 7.1)
15-0357 Rev. 0
H.
If
using Surround Sound speakers, connect speaker wires
to
speakers keeping polarity constant so speakers are in proper phase.
I.
If using
an
lyriO'"
system, a dual male
to
dual male
RCA
cable will need to
be
sourced
to
connect the line level stereo receiver output to
the
RCA
inputs
of
the
lyriQTJl
Source Input.
J. The RG6QS cable thai was run from the HECC to the 1 port outlet (sub-woofer) location should
be
pulleo through the single gang box or
mud
ring,
and
terminated with
an
"F"
connector. Once terminated, attach
the
cable
10
the
RCA
to
"F"
Connector Insert
(PIN
364296-1Ol),
and attach the 1 port outlet to the single gang box
Of
mud ring. A single male "RCA" to dual mate "RCA" Y-eable. such as the subwoofer
RCA Y cable
(PIN 364795-01), is available to
allach
the sub-woofer to the outlet.
K.
Connect all equipment and devices
as
applicable, Always checl< for proper speaker polarity.
L.
Sort and position the cables entering the front
of
the HECC to allow allachment
of
cover.
M. Hook cover
on
top
of
insert with plunger pulled out to open position. Engage plunger with the hole in the insert. Push in plunger
to
secure
cover to insert.
4.
Tips
A.
To
insure the speakers are Installed -in-phase" follow a standard wiring
pallem
such as "+" on the HECC label goes to the red terminal
on the speaker
over
the wire with the label
and"
-"
on
the HECC label goes
to
the black terminal on the speaker over the wire without the
label. Wiring the speakers out
of
phase will decrease their sound output dramatically and cause significant distortion.
B.
The opening should be level and square. It may be helpful
to
put the HECC Insert in the frame before tightening screws.
Figure
5
ClCopyright 2006
by
On·OILegrand All Rights Reserved.
Figure
6
Figure
7
Page30f3