Drawing

INSTRUCTION / INSTALLATION SHEET
evōQ™ 3000 Dual Voice Coil Speaker
IS-0258 Rev. C
301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone [phone] / Fax [phone]
www.onqlegrand.com
©Copyright 2007 by On-Q/Legrand All Rights Reserved. Page 1 of 3
1. Introduction
On-Q/Legrand offers a high end 6.5”, Dual Voice Coil, In-Ceiling,
evōQ™ 3000 speaker for those instances where the room size or
shape does not accommodate a pair of speakers. This speaker,
On-Q part number MS3652 (see Figure 1), is optimized for
audio distribution (central sound), and features a Poly woofer
and dual PEI (Polyetherimide) Mylar tweeters. This speaker
comes with a dual template with center markings and a paint
ring. An optional speaker pre-construction bracket is available.
Disclaimer: Make sure you are in compliance with local building
codes before installing this speaker. This On-Q/Legrand evōQ™
3000 In-Ceiling Speaker is suitable for moisture rich environments
such as bathrooms or saunas, but not outdoor applications.
2. Description
The On-Q/Legrand evōQ™ 3000 speakers are made of a tough semi-flexible plastic frames that feature a
built in foam gasket to minimize vibration and maximize seal-ability. They also feature a perforated metal grill
with an acoustically transparent scrim cloth to enhance the speakers appearance once installed
. All evóQ
speakers, except sub woofers, are paint-able. They also come with painting shields to protect the drivers
while painting. These speakers are suitable for moisture rich environments. They also feature flip out tabs for
easy installation and removal.
3. Installation
Installation of this evōQ™ 3000 speaker is best accomplished at multiple times during new construction, at
“Rough-in” before the drywall is installed, and at “Trim-out” after the drywall is installed and painted.
A. “Rough-in” steps:
NOTE: It is recommended that a minimum of 16 gauge, 4 conductor wire be
used for most applications from the amplifier or volume control to this speaker.
Different gauges can, and should, be used based upon the distance of the
intended run or quality of installation (see Figure 2).
NOTE: All On-Q/Legrand lyriQ™ Audio components accommodate wire gauges
from 18 to 14.
1. Run x/4 conductor (x=gauge preference) stranded speaker wire from the distribution/volume control
to the speaker location (pre-wiring).
Distance Gauge
<10 Feet 18
10-50 Feet 16
>50 Feet 14
Speaker Wire
Gauge Selection Chart
Figure 2
On-Q/Legrand evōQ™ 3000 6.5” Dual
Voice Coil Speaker P/N MS3652
(shown w/o grill)
Figure 1