Data Sheet

ManualsBrandsON SEMICONDUCTOR ManualsLogic ICsLogic IC - Buffer, driver SOT 23 5

October-2017, Rev . 2 NC7SZ125/D

NC7SZ125— TinyLogic

UHS Buffer with Three-State Output

NC7SZ125

TinyLogic

UHS Buffer with Three-State Output

Features

 Ultra-High Speed: t

2.6 ns (Typical) into 50 pF

at 5 V V

 High Output Drive: ±24 mA at 3 V V

 Broad V

Operating Range: 1.65 V to 5.5 V

 Matches Performance of LCX Operated at

3.3 V V

 Pow er Dow n High-Impedance Inputs/Outputs

 Over-Voltage Tolerance Inputs Facilitate 5 V to 3 V

Translation

 Proprietary Noise/EMI Reduction Circuitry

 Ultra-Small MicroPak™ Packages

 Space-Saving SOT23 and SC70 Packages

Description

The NC7SZ125 is a single buffer w ith three-state output

from ON Semiconductor's Ultra-High Speed (UHS) of

TinyLogic

. The device is fabricated w ith advanced CMOS

technology to achieve ultra high speed w ith high output

drive w hile maintaining low static pow er dissipation over

a very broad V

operating range. The device is specified

to operate over the 1.65 V to 5.5 V range. The inputs and

output are high impedance above ground w hen V

0 V. Inputs tolerate voltages up to 6 V independent of V

operating voltage. The output tolerates voltages above

w hen in the 3-STATE condition.

Ordering Information

Part Number

Top Mark

Package

Packing Method

NC7SZ125M5X

7Z25

5-Lead SOT23, JEDEC MO-178 1.6 mm

3000 Units on

Tape & Reel

NC7SZ125P5X

Z25

5-Lead SC70, EIAJ SC-88a, 1.25 mm Wide

3000 Units on

Tape & Reel

NC7SZ125L6X

6-Lead MicroPak™, 1.00 mm Wide

5000 Units on

Tape & Reel

NC7SZ125FHX

6-Lead, MicroPak2, 1x1 mm Body, .35mm Pitch

5000 Units on

Tape & Reel

Summary of content (12 pages)

PAGE 1
Features Description  The NC7SZ125 is a single buffer w ith three-state output from ON Semiconductor's Ultra-High Speed (UHS) of TinyLogic ®. The device is fabricated w ith advanced CMOS technology to achieve ultra high speed w ith high output drive w hile maintaining low static pow er dissipation over a very broad V CC operating range. The device is specified to operate over the 1.65 V to 5.5 V range. The inputs and output are high impedance above ground w hen V CC is 0 V.
PAGE 2
IEEE/IEC Figure 1. Logic Sym bol Pin Configurations Figure 2. SC70 and SOT23 (Top View ) Figure 3. MicroPak™ (Top Through View ) Pin Definitions Pin # SC70 / SOT23 Pin # MicroPak Name Description 1 1 OE Input 2 2 A Input 3 3 GND Ground 4 4 Y Output 5 6 V CC Supply Voltage 5 NC No Connect Function Table Inputs Output /OE In A Out Y L L L L H H H X Z H = HIGH Logic Level L = LOW Logic Level X = HIGH or LOW Logic Level Z = HIGH Impedance State www.onsemi.
PAGE 3
Stresses exceeding the absolute maximum ratings may damage the device. The device may not f unction or be operable above the recommended operating conditions and stressing the parts to these levels is not recommended. In addition, extended exposure to stresses above the recommended operating conditions may affect device reliability. The absolute maximum ratings are stress ratings only. Symbol Parameter Min. Max. Unit V CC Supply Voltage -0.5 6.0 V V IN DC Input Voltage -0.5 6.
PAGE 4
25 MicroPak-6 500 MicroPak2-6 560 Note: 1. Unused inputs must be held HIGH or LOW. They may not float. www.onsemi.
PAGE 5
Symbol Parameter VCC Conditions Min. V IH V IL Min. 0.75V CC 0.75V CC 2.30 to 5.50 0.70V CC 0.70V CC LOW Level Input Voltage 1.65 to 1.95 0.25V CC 0.25V CC 2.30 to 5.50 0.30V CC 0.30V CC HIGH Level Output Voltage LOW Level Output Voltage Units Max. 1.65 to 1.95 V V 1.65 1.55 1.65 1.55 1.80 1.70 1.80 1.70 2.20 2.30 2.20 3.00 2.90 3.00 2.90 4.50 4.40 4.50 4.40 V IN=V IH, IOH=-100 µA 1.65 IOH=-4 mA 1.29 1.52 1.29 2.30 IOH=-8 mA 1.90 2.15 1.90 3.
PAGE 6
Sym bol tPLH, tPHL tPZL, tPZH Param eter Propagation Delay Output Enable Time V CC CIN Output Disable Time TA=+25°C Min. TA=-40 to +85°C Typ. Max. Min. Max. 1.65 2.0 6.4 13.2 2.0 13.8 1.80 CL=15 pF, 2.50 ±0.20 RD=1 M  3.30 ±0.30 S 1=OPEN 2.0 5.3 11.0 2.0 11.5 0.8 3.4 7.5 0.8 8.0 0.5 2.5 5.2 0.5 5.5 5.00 ±0.50 0.5 2.1 4.5 0.5 4.8 3.30 ±0.30 CL=50 pF, RD=500   5.00 ±0.50 S =OPEN 1 1.5 3.2 5.7 1.5 6.0 0.8 2.6 5.0 0.8 5.3 1.65 2.0 8.4 15.0 2.0 15.
PAGE 7
Figure 5. ICCD Test Circuit Figure 6. AC Waveform s www.onsemi.com 7 NC7SZ125 — TinyLogic® UHS Buffer with Three-State Output Note: 4. Input=AC Waveform; tr=tf=1.8 ns; PRR=10 MHz; Duty Cycle=50%.
PAGE 8
NC7SZ125 — TinyLogic® UHS Buffer with Three-State Output Physical Dimensions 3.00 2.80 5 SYMM CL 0.95 0.95 A 4 B 3.00 2.60 1.70 1.50 1 2 2.60 3 (0.30) 1.00 0.50 0.30 0.95 0.20 1.90 C A B 0.70 TOP VIEW LAND PATTERN RECOMMENDATION SEE DETAIL A 1.30 0.90 1.45 MAX 0.15 0.05 0.22 0.08 C 0.10 C NOTES: UNLESS OTHEWISE SPECIFIED GAGE PLANE A) THIS PACKAGE CONFORMS TO JEDEC MO-178, ISSUE B, VARIATION AA, B) ALL DIMENSIONS ARE IN MILLIMETERS. C) MA05Brev5 0.25 8° 0° 0.55 0.35 0.
PAGE 9
NC7SZ125 — TinyLogic® UHS Buffer with Three-State Output Physical Dimensions Figure 8. 5-Lead, SC70, EIAJ SC-88a, 1.25 m m Wide Package drawings are provided as a service to customers considering ON Semiconductor components. Drawings may change in any manner without notice. Please note the revision and/or date on the drawing and contact a ON Semiconductor representative to verify or obtain the most recent revision.
PAGE 10
NC7SZ125 — TinyLogic® UHS Buffer with Three-State Output Physical Dimensions 2X 0.05 C 1.45 B 2X (1) 0.05 C (0.254) (0.49) 5X 1.00 (0.75) PIN 1 IDENTIFIER 5 (0.52) 1X A TOP VIEW 0.55MAX (0.30) 6X PIN 1 0.05 C 0.05 0.00 RECOMMENED LAND PATTERN 0.05 C C 1.0 DETAIL A 0.10 0.05 0.45 0.35 0.10 0.00 6X 0.25 0.15 6X C B A C 0.40 0.30 0.35 5X 0.25 0.40 5X 0.30 0.5 (0.05) 6X BOTTOM VIEW DETAIL A PIN 1 TERMINAL 0.075 X 45 CHAMFER (0.13) 4X Notes: 1.
PAGE 11
NC7SZ125 — TinyLogic® UHS Buffer with Three-State Output Physical Dimensions 0.89 0.35 0.05 C 1.00±0.050 2X B A 5X 0.40 PIN 1 MIN 250uM 0.66 1.00±0.050 1X 0.45 6X 0.19 0.05 C TOP VIEW RECOMMENDED LAND PATTERN FOR SPACE CONSTRAINED PCB 2X 0.90 0.05 C 0.35 0.50±0.05 C 5X 0.52 SIDE VIEW 0.73 1X 0.57 6X (0.08) 4X 1 DETAIL A 2 3 0.14±0.05 0.20 6X ALTERNATIVE LAND PATTERN FOR UNIVERSAL APPLICATION (0.05) 6X 5X 0.30±0.05 6 5 4 0.60 0.35 (0.08) 4X 0.10 .05 C C B A 0.35±0.
PAGE 12
NC7SZ125 — TinyLogic® UHS Buffer with Three-State Output ON Semiconductor and the ON Semiconductor logo are trademarks of Semiconductor Components Industries, LLC dba ON Semiconductor or its subsidiaries in the United States and/or other countries. ON Semiconductor owns the rights to a number of patents, trademarks, copyrights, trade secrets, and other intellectual property. A listing of ON Semiconductor’s product/patent coverage may be accessed at www.onsemi.com/site/pdf/Patent-Marking.pdf.