HONDURAN EDGE PREMIUM SERIES Corrugated Asphalt Roofing Panels INSTALLATION INSTRUCTIONS for all types of projects * Will not rust or corrode like metal roofing Lo e Installs over solid decking or aver shingles LBl Limited Lifetime Warranty Color Options RED GREEN BROWN e T Corrugation height Ie 1.
THANK YOU for chasing ONDURA® EDGE PREMIUM SERIES for your roofing project. el T LTS Installation of roofing materials can be dangerous, Danger typically increases as the steepness of the roof pitch and the height from the ground. Inclement weather conditions and numerous other factors can also contribute to the relative danger. We strongly recommend that anyone Installing ONDURA® or working on a roof n any manner take all possible precautions to ensure their personal safety at all times.
If possible, we recommend placing the first row of ONDURA® panels on the roof to confirm coverage overlaps before installation of the panels. PLACEMENT OF ONDURA® PANELS If more than one row of ONDURA® panels Is needed, then the panels must be installed along the eave first. Then additional rows are installed above the previous rew. Stagger the position of the corrugation overlap for each row by starting the second row with a panel that has fewer corrugations.
FASTENER INSTALLATION Drive ONDULINE® screws only through the crown of the corrugation and always perpendicular to the roof's surface. Be careful not to overdrive the screw. The rubber washer on the screw should snugly contact the panel without dimpling the panel. When appropriately installed, slight hand pressure on an affixed corrugation should not separate the panel from contacting the washer. Install screws on the first panel along the eave and rake edges.
VALLEY FLASHING For valleys, install a minimum 18-inch wide metal valley flashing. Cut sheets at an angle to fit the valley; then turn over, and on the undersides along the valley edge, caulk two corrugations of the ONDURAS® closure strip, and place into the corrugation. Then pita ¥-inch bead of caulking on the flat side of the closure strips and along the corrugation of the sheet between the closure strips.
HONDURAN PREMIUM SERIES PANELS Length 79 inches Weight of Product 11.91bs Width 35 inches Weight of Gross Surface 0.62 Ibsen? Thickness cinch Corrugations Flatboats Corrugation Height 1.5 inches Overlap 4 inches Corrugation Pitch cinches Net Coverage Area ~6.25 panels/100 ft* Product Surface 19.2ft2 RIDGE CAPS FASTENERS w Length 39.