Instructions / Assembly

ManualsBrandsOndura ManualsBuilding materialsFasterners Hex Head Screws in Red

BROWN

BLACK

ONDURA® makes installation fast

and easy for all types of projects

Q 

Q

Q 

Q 

Q 

Q 

Q 

Q 

Q 

Q 

Choice of colors:

ǁŝƚŚŝŵƉƌŽǀĞĚǁŝŶĚƉĞƌĨŽƌŵĂŶĐĞŝŶƐƚĂůůĂƚŝŽŶ



I N S T A L L A T I O N I N S T R U C T I O N S

RED

GREEN

DRAFT

Summary of content (5 pages)

PAGE 1
Corruggated Asphalt Rooﬁng Corru Rooﬁng Sheets I N S T A L L A T I O N I N S T R U C T I O N S ONDURA® makes installation fast and easy for all types of projects Q Will not rust or corrode Q Installs over solid decking or purlins Q Can be installed over shingles Q Wind resistant to 120 MPH ǁŝƚŚ ŝŵƉƌŽǀĞĚ ǁŝŶĚ ƉĞƌĨŽƌŵĂŶĐĞ ŝŶƐƚĂůůĂƚŝŽŶ DRAFT Q Quieter than metal roofing Q Does not radiate heat or cold Q Lightweight Q Easy to trim and install—no sharp edges Q No special tools required Q Lifetime
PAGE 2
Thank you for choosing ONDURA® PREMIUM SERIES for your roofing project ONDURA® should be carefully installed. Mistakes during the installation can cause problems later and impact warranty. Please take the time to closely follow these installation guidelines.
PAGE 3
INSTALLATION STAGE If possible, we recommend placing the first row of ONDURA® sheets on the roof to confirm coverage overlaps before installation of the sheets. Placement of ONDURA® Sheets If more than one row of ONDURA® sheets is needed, then the sheets must be installed along the eave first. Then additional rows are installed above the previous row. Fixation Positioning Genuine ONDULINE® Fixations are recommended for use on all ONDURA® products.
PAGE 4
ONDULINE® Fixation Instructions Rake Trim Drive ONDULINE® screws only through the crown of the corrugation and always perpenicular to the roof's surface. Be careful not to overdrive the screw. The rubber washer on the screw should snugly contact the panel without dimpling the sheet. When appropriately installed, slight hand pressure on an affixed corrugation should not sperate the sheet from contacting the washer.
PAGE 5
Insert ridge closure strip above ONDURA® panel and below the ridge cap after all ONDURA® panels have been placed. The closure strip must be placed where the fixations will be located to secure the closure strip. The center of the closure strip should be 1 inch above the lowest end of the ridge cap. Install fixations through the ridge cap and closure through every crown (top of corrugation) of the underlying ONDURA®. The fixations should be 1 inch above the lower edge of the ridge cap.