Dimensions Guide
Table Of Contents
Technical Data Sheet
T06203 - V01 - 03-2019 - NA01
ONDURA
®
PREMIUM SERIES
RIDGE-VERGE ACCESSORY B100
Material / Application
Lightweight bitumen accessory designed for all buildings covered
with ONDURA® roofing system to provide a weatherproof seal at the
ridge and at the verge.
Bitumen material reinforced with cellulosic fibers and thermosetting
resin. The composite is colored with inorganic pigments.
Technical characteristics
Length L
39.5 inches
Width at 0° w
16 inches
Flat width Fw
1/8 inch
Height of accessory H
NA
Thickness t
1/8 inch
Surface
4.4 ft²
Weight
2.4 lbs
Weight per m²
0.5 lb/ft²
MECHANICAL & PHYSICAL PROPERTIES
Color
Red
Green Brown
Black
1
No area larger than 1 cm² without bitumen
Estimating
Number of Ridges for Project =
ℎ
(
ℎ
)
+8 ℎ
32.5 ℎ
Installation
Special conditions for this installation are required. Please refer to the
installation guide.
This Technical Data Sheet was made based on currently available information as of May 14,
2020. Product was made in accordance with above mentioned parameters, but
producer/distributor can’t anticipate any future change
or any changes in regulations. It is the
consumer’s responsibility to use the product in accordance to producer/distributor
recommendations and their needs. All the claims will be considered with respect to
application recommendations issued by Onduline North America, Inc.
Onduline North America, Inc.
4900 Ondura Drive
Fredericksburg, VA 22407
United States of America
Tearing strength
≥ 200 N
Proportion of bitumen > 40%
Homogeneity
Pass
1
Water absorption < 20%
Tearing Strength ≥ 200 N
Thermal Coefficient < 100.10-6 1/K