Instructions / Assembly
5
For resistance to wind upli,
the maximum distance from
the eave edge of a sheet to
the rst row of nails is 3.25
inches.
Install nails on the rst sheet
along the eave and rake
edges.
Tip: For each row of nails, install the rst two nails at
opposite sides of the sheet and aach a string line
between them—across the corrugaons—as a guide
for the posion of the other nails. Mark the posion
of the string on the crown of each corrugaon with a
pencil. Repeat for each row of nails.
Install nails at remaining posions, but do not fasten areas
which will be overlapped by other sheets.
Place next ONDURA-6V sheet into posion on roof.
n The sheets must overlap by at least one corrugaon along
the direcon of the eave.
n The sheets should overlap by at least 7 inches along the
direcon of the rake edge.
Install nails on the next sheet in the same manner as the
rst sheet.
For the last sheet in a row, install nails in the same paern as
previous sheets and in the nal corrugaon along the rake edge.
Drive each ONDURA nail only through the crown of a
corrugaon and perpendicular to the roof surface. Be careful
not to overdrive or underdrive the nail. The rubber washer on
the nail should be snugly in contact with the sheet. Slight hand
pressure on a nailed-down corrugaon should not separate the
sheet from washer contact.
Correct Incorrect Incorrect
3.25 inch max
For valleys, install a minimum 24˝wide metal valley ashing. Cut
sheets at an angle to t the valley; then turn over, and on the
undersides along the valley edge, caulk one corrugaon of the
ONDURA-6V eave closure strip, and place into the corrugaon.
Then put a 1/2˝ bead of caulking on the at side of the closure
strips and on the sheet between the closure strips. Turn sheets
right side up, carefully lay in place so caulked closures seat on
ashing, and nail in place at least 12˝ up from the center of
valley without puncturing the metal ashing.
See below examples on how to ash when ONDURA-6V roong
meets a wall.
2-5 inches
from valley
Headwall
ONDURA-6V
Ridge closure
under ashing
Fastener
Flashing
Sidewall covering
Deck
sheathing
Sidewall
ONDURA-6V
Fastener
Flashing
Sidewall covering
Sloping
raer
Deck
sheathing
Sidewall
ONDURA-6V
Fastener
Flashing
Sidewall covering
Sloping
raer
Deck
sheathing
Opon 1 Opon 2