Instructions / Assembly
7
RIDGE FOR PITCH BELOW 10/12
1
The Apron Piece is installed on
both sides of the roof to secure
waterghtness. At the verge, the
Apron Piece has to be cut on site
parallel to the last corrugaon of
the shingle.
2
At low pitches (below 4/12),
so fastening is recommended
in order to avoid the possible
deformaon of the Slim Cap.
5
Foam closures can be fastened
below the ridge piece, in order
to prevent birds or other animals
from entering the roof space.
6
Install Closure Strips. Install Slim
Cap over Apron Piece maintaining
proper overlap and fastening
schedule.
4
For pitches above 8/12, it is
necessary to cut the at part
above the corrugaons.
3
RIDGE FOR PITCH ABOVE 10/12
The Slim Cap can be used for pitches up
to 10/12. Above that limit, the Standard
Ridge piece should be used.
Verge Piece
1
Install Closure Strips. Install ridge
fastening through corrugaons.
Closure Strips
Standard Ridge
piece
2
Gap for venlaon
Gap for venlaon
Cut the Apron
Piece
Verge Piece
Verge Piece
Gap for venlaon
Overlap
Overlap
Slim Cap
Apron Piece
Soft xing
Closure Cap
Slim Cap
Run shingles to ridge. Leave gap
for venlaon if desired.
Closure Strip