Instruction manual

19
p
ress “video” over and over
until you can see the picture
of the dvd playing.
NO
picture
Input/AV funtion in SmartControl
W
hen in SmartControl (watch tv, watch movie, listen to music) the “help” function enables you to
find the correct A/V (audio/video) input. Simply press “audio” over and over until you hear the
sound of the corresponding device (e.g. amp or mp3)....or press “video” over and over to see the
picture of the corresponding device (e.g. stb or dvd).
DVDDVD
dvd
playing
DVDDVD
dvd
playing
Now you should hear the
d
vd playing. If NOT please
r
epeat this procedure
pressing the “audio” key.
The ONE FOR ALL is not
performing commands
properly?
Problem - Solution
Try the Search Method.
Your brand is not listed in the
Code List?
-
-
You may be using the wrong code!
• For SimpleSet: Simply repeat SimpleSet.
• For Direct Code Set Up:Try the next code listed for your brand.
• For the Search Method: Start the Search Method again to locate
the proper code.
Example 1 (configuration as shown):
H
ow to activate “watch tv” combination 1
1) Press and hold magic key for 3 sec. --> The Blue ring will light up twice.
2) Press and release “watch tv”.
3) Press and release “1”.
E
xample 2:
How to activate “watch movie” combination. 2
1) Press and hold magic key for 3 sec. --> The Blue ring will light up twice.
2) Press and release “watch movie”.
3) Press and release “2”.
E.g. How to activate the “help” function for finding the video (or audio for
amp/mp3) -input in SmartControl in “watch tv” mode.
1) Press and hold magic key for 3 sec. --> Blue ring will light up twice.
2) Press (e.g.)Watch tv. Blue ring will light up twice.
3) Press video (or audio). Blue ring will light up twice.
E.g. To deactivate the “help” function in SmartControl in “watch tv” mode.
1) Press and hold magic key for 3 sec. --> Blue ring will light up twice.
2) Press (e.g.) Watch tv. Blue ring will light up twice.
3) Press video (or audio). Blue ring will light up 4 times.
• If the “help” function is providing wrong A/V input(s) or a different function
you may be using the wrong code. Please repeat the “SimpleSet” procedure
or try the next code within the “Direct Code Set Up” procedure.
If the “help”function is NOT working it needs to be activated.
URC-7960_MANUAL-V1-RDN-1071009-1020:URC-7960 07-10-2009 14:53 Pagina 19