Operation Manual

11
Operation
Startup
Plug the AC Power Cord into AC wall outlet. Before switching on the unit, make sure that the
voltage of your electricity supply is the same as that indicated on the rating plate.
Put the antenna to a suitable place and connect to the antenna jack on the rear of the device.
Time Setting
This unit will automatically sync the time from radio station once it is connected to the AC. It
may take several minutes for the rst sync.
Setting the Timer
• Press the TIMER 1 or TIMER 2 and press DOWN/UP button to turn on the alarm.
• Press the ENTER button to conrm. The display will show “00:00” (HOUR: MINUTE).
• Press UP/DOWN to select the desired hour and press the ENTER button to conrm.
• Press UP/DOWN to select the desired minute and press the ENTER button to conrm.
• Press UP/DOWN to select the desired alarm volume and press the ENTER to conrm.
• The timer will start and increase gradually to the desired volume setting. (The default
setting is Volume 9. )
• To switch off the timer, Press the TIMER 1 or TIMER 2 button correspondingly.
NOTE: Timer 1 and Timer 2 have two different alarm sound. Both alarms will stop auto-
matically after 5 minutes.
FM Radio
• Press the STANDBY button to turn on the Radio.
• Press the MODE button to select FM band.
• Press the AUTO SCAN button to the next available radio station or hold the AUTO SCAN
button to the previous available radio station.
• For Manual Tuning, press the UP and DOWN button to tune up or down the frequency by
MHz.
• Press Enter button to select the MONO or AUTO mode.
• Press the STANDBY button again to turn off the FM Radio.
DAB Radio
• Press the STANDBY button to turn on the Radio.
• Press the MODE button to select DAB band.
• Press the AUTO SCAN button to the auto full scan.