Operation Manual

BT Operation (10009513, 10009514)

1.Turn on the Music System by pressing the STAND-BY BUTTON. The LCD DISPLAY lights on.

2.PressMODEbuttontochoosetheBTmode.TheBTlightwillash.

3.Open the BT device and search other BT devices. Choose V329 and connect.

4. Play the music: The BT will remember the last connection and will connect it automati-

cally. It may cause that the music system can not connect to others if it connects too

many devices. Please hold PLAY/PAUSE Button two seconds to clean the memory.

AUX Operation

You can play other music sources (iPod, MP3 player or other digital audio player) through

the speakers of this System by connecting the AUX IN Jack to your external player’s LINE

OUT jack or headphone jack.

1. The AUX IN and PHONES JACKS are covered by the DOOR (#16). Slide the DOOR downwards

2. Plug one end of an audio cable (Not included) into the AUX IN Jack and the other end of

the cable to the line out or headphone jack of your digital audio player.

3. Press the STAND-BY BUTTON to turn on the System. The LCD DISPLAY goes “On”.

4. Play your digital audio player.

5. Adjust the VOLUME on the external audio player and the System until you reach a com-

fortable listening level.

6. TurntheSystemandyouraudioplayerowhenyouhavenishedlisteningandunplug

the audio cable.

Setting the Alarm

SETTING THE WAKE UP TIME and Alarm to FM/CD/USB/CARD/Buzzer

1. Under stand-by status, press ALARM SET button more than 2 seconds, the alarm time

ondisplaywillshfor6seconds.

2. Within 10 seconds Press HOUR button and MINUTE to adjust the time and press Alarm

Set button again to member the setting.

3. Within 10 seconds ,press ALARM SET button to select the timer playback source

(FM,CD.USB.CARD, Buzzer)

4. Hold down ALARM SET button for 2 seconds,the display will show the “MEMERY”.

5. When the timer end time is reached, the system will enter the power stand-by mode

automatically.

Notes: When performing timer playback using another unit connected to the USB terminal

or SD , select “USB” or “SD” in step 3. This unit will turn on or enter the power stand-by

mode automatically.