- Oneida Ltd. Direct Drive Cyclonic Dust Collectors Owner's Manual

X. Accessories

O.A.S. 2002

5 - 7.5 HP Direct Drive Owner’s Manual

Dust Bin Options - (Must Order Custom Mounting Stand.)

2. Hoppers -

Large capacity hoppers from .5 cu. yd. to 3 cu. yd.

3/16” reinforcing angle for added support - 3/16” plate body is

100% continuously MIG welded on inside - 3/8” rear cross brace

angle (not 3/16”) - three 3” base channel - All angles are structural

not formed.

3. Air Locks -

Rotary air locks provide an alternative to an air tight dust bin

for larger volume capacity and less maintenance.

Example - A 10” air lock will drop 1.85 cu. ft. / rev. of material.

1. Multiple Drums -

Custom order the System Mounting Stand for multiple drums

or hoppers. Stand widths will vary depending on dust container.

Magnetic Motor Starters - The 5 and 7.5hp direct drive dust

collectors do not come wired or with an on/off switch. Because

of the voltage and amperage requirements of the system, an

industrial switch must be used.

OAS offers Square “D” Full Voltage Non-Reversing across

the Line Starters, Nema Type 1 Enclosure with Start/Stop in

cover, and class 10 overload. Industrial switches can also be

purchased through your local electrician. Due to varying

electrical codes, OAS cannot specify exact wiring requirements.

When wiring the collector you should always hire a licensed

electrician.

Bindicator - Provides level sensing for dry bulk solids. The

Bindicator operates by using a 1 rpm synchronous motor to

rotate a paddle.

When paddle rotation is impeded by material surrounding it,

the motor is de-energized and triggers a SPDT snap switch.

The snap switch can be used in conjunction with a motor

starter to turn equipment off or provide alarm functions.