- Oneida Ltd. Direct Drive Cyclonic Dust Collectors Owner's Manual

VI. Assembly Instructions
O.A.S. 2002
c
5 - 7.5 HP Direct Drive Owner’s Manual
Cyclone
Barrel
Cyclone
Barrel
Air Inlet
Fan / Blower
1.
1. Orient the blower housing to match the stand
configuration and the desired angle for the cyclone inlet.
Bolt the fan / blower to the cyclone barrel using the
hardware taped on the motor.
Bolts are already welded on Fan/Blower unit. Put a bead
of silicone around top hole in cyclone barrel, then put
bolts through holes in barrel. Put flat washer on bolt.
then lock washer, then hex nut.
Cyclone
Cone
2.
3.
2. Bolt the fan housing and cyclone barrel to the cyclone
cone using hardware taped to cyclone barrel. Note: the
fan / blower and the cyclone barrel are very heavy. The
system will be top heavy. One method is to lay the stand
down, then bolt the cyclone with the fan / blower to the
stand. The iron ring will be on top of the cross bars of
the stand. Put bead of silicone around inside edge of
flange on the cyclone cone. Then put bolt through flat
washer, then bolt through holes in both flanges, thenput
lock washer on bolt, then attach hex nut.
Cyclone Inlet and Fan / Blower are independent.
Filters can be to the right or left of the unit.
3. Tip the fan housing and cone upright. The system is
very top heavy. Place plenum on top of the plenum
stand.
4. Bolt the plenum to the fan housing outlet (rectangular).
Clamp the cartridges to the plenum. Clamp the dust
bins to the bottom of the cartridge filters.
Plenum
Stand
Cartridge
Filters
Dust Bins
Outlet
Air
Outlet
Continued on next page.
7
Silicone
Bead
Silicone
Bead
Bolt
Flat Washer
Flange
Lock Washer
Hex Nut
16 ea. 3/8” Flat Washers, Lock Washers and Hex Nuts
16 ea. 3/8” Flat Washers,
Lock Washers, Hex Nuts
and 3/8 x 1” Bolts
Fan / Blower is shipped strapped to Cyclone Barrel. It is NOT
attached to the unit. You must bolt them together. Follow the
instructions below.