™ OneSpace is a Trademark of Comfort Products, Inc.
Desktop maximum weight capacity = 40lbs Drawer maximum weight capacity = 10lbs 2 OF 12
Drawer Front Panel Drawer Left Panel Drawer Right Panel 51-7005HAES - READ THE INSTRUCTION MANUAL BEFORE ASSEMBLING. - REMOVE ALL PIECES BEFORE BEGINNING INSTALLATION. - OPEN THE HARDWARE AS NEEDED. - ASSEMBLE IN AN AREA WITH PLENTY OF SPACE. - READ EACH STEP BEFORE BEGINNING CONSTRUCTION. - HAVE THE TOOLS BELOW BEFORE YOU BEGIN ASSEMBLING. - NEVER FORCE THE SCREWS OR FITTINGS. - KEEP THIS MANUAL FOR FUTURE REFERENCE. - TIGHTEN ALL THE SCREWS EVERY 6 MONTHS.
X2 X2 predrilled holes.
Screw two Drawer Slides (3-CL) to the Left Outside Shelf Panel (E) using Euro Screws (4). Then screw two Drawer Slides (3-CR) to the Right Side Panel (B) using four Euro Screws (4).
Screw Left Outside Shelf Panel (E) to Bottom Shelf Panel (F) with one Unitar Screw (5) using predrilled holes. (Make sure finished sides are facing outwards) Attach Back Panels (D and K) to Side Panels (A and B) with six Unitar Screws (5) using predilled holes (making sure both Back Panels finished ends are facing inside and towards each other). Then, using rubber hammer, hammer four plastic Nail Legs (6) into the bottom of Side Panels (A and B).
Attach Shelf Panels (E and F) with three Unitar Screws (5) using predrilled holes (making sure finished side is facing front of desk). E Press in each of the five Cams (7), making sure the arrow on top is pointing towards the smaller hole. Attach Desktop (C) to desk by aligning the Minifix Bolts (2) into the smaller holes. Turn the Cam clockwise to lock it into the Minifix Bolt (2). Caution: Do not over tighten cams.
Attach Sides of Drawer (H and I) to Drawer Front Panel (G) by first pressing each Cam (7) into the larger hole, making sure the arrow is pointed towards the smaller hole. Align Minifix Bolts (2) with the smaller holes. Turn each Cam clockwise to lock it into the Minifix Bolt (2). Slide Drawer Bottom Panel (Z) between Panels (I and H). (Making sure finished side is facing inside the drawer). Then attach Drawer Back Panel (J) with four Long Screws (8) into predrilled holes.
Attach Handle (9) to Drawer Front Panel with two Screws (9), making sure the lip of the handle is facing the bottom of the drawer.
Attach Drawer Slides (10) to the bottom of drawer using four Short Screws (11).
Use the eight Round Stickers (12) to cover all exposed screws on the exterior of your new desk.
• • • • DO NOT stand on the desk. Do not use the desk as a stepladder. DO NOT use the desk unless all bolts and screws are firmly secured. Every 6 months, check all bolts and screws to ensure they are tight. This product is California 93120 Compliant for Formaldehyde. PLEASE VISIT WWW.COMFORTPRODUCTS.NET FOR WARRANTY INFORMATION Comfort Products warrants this product to be free from defects in material and workmanship for one (1) year.