MSDS

RD-0037-CA - Onetime Spackling – ½ pint, Quart & Pint
Revision Date: 23-Apr-2014
_____________________________________________________________________________________________
_____________________________________________________________________________________________
Page 3 / 7
Methods for Clean-Up
Pick up and transfer to properly labeled containers. Take up with sand or other
non-combustible absorbent material and place into containers for later disposal. Do not mix
with wastes from other materials. Wash area with soap and water.
7. HANDLING AND STORAGE
Advice on Safe Handling
Keep out of reach of children and pets. Do not take internally. Do not breathe vapors. Use
only with adequate ventilation. Wash thoroughly after handling. Avoid contact with eyes,
skin and clothing. Open windows and doors to ensure cross-ventilation and fresh air during
application and curing. When using do not eat, drink or smoke. See section 6 of this SDS
for clean up instructions. Use personal protection recommended in Section 8. Do not
handle until all safety precautions have been read and understood. Obtain special
instructions before use.
Storage Conditions
Keep containers tightly closed in a dry, cool and well-ventilated place. Protect from direct
sunlight. Do not store at high temperatures. Protect from freezing. Store away from
incompatible materials. To maximize shelf life, store at temperatures below 26°C (80°F).
Store locked up.
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Exposure Guidelines
Component
ACGIH TLV
OSHA PEL
NIOSH IDLH
Canada -
Alberta -
Occupational
Exposure
Limits -
Ceilings
Canada - British
Columbia -
Occupational
Exposure
Limits -
Ceilings
Canada -
Manitoba -
Occupational
Exposure
Limits -
Ceilings
Canada - New
Brunswick -
Occupational
Exposure
Limits -
Ceilings
Canada -
Newfoundland
& Labrador -
Occupational
Exposure
Limits - Ceilings
Soda lime borosilicate
glass
65997-17-3 ( 10-30 )
TWA: 1
fiber/cm3
respirable fibers:
length >5 µm,
aspect ratio
>=3:1, as
determined by
the membrane
filter method at
400-450X
magnification
[4-mm objective],
using
phase-contrast
illumination
TWA: 5 mg/m
3
inhalable fraction
-
-
TWA: 5 mg/m
3
TWA: 1
fibre/cm3
TWA: 1
fibre/cm3
TWA: 5 mg/m
3
-
-
-
Engineering Controls
Ventilation must be adequate to maintain the ambient workplace atmosphere below the
exposure limit(s) outlined in the SDS.
Personal protective equipment (PPE)
Eye/Face Protection
Use approved safety goggles or safety glasses. If necessary, refer to appropriate
regulations & standards.
Respiratory Protection
If exposure limits are exceeded or irritation is experienced, NIOSH/MSHA approved
respiratory protection should be worn. Positive-pressure supplied air respirators may be
required for high airborne contaminant concentrations. Respiratory protection must be
provided in accordance with current local regulations.
General Hygiene Considerations
Handle in accordance with good industrial hygiene and safety practice. Wash hands before
breaks and immediately after handling the product. Take off all contaminated clothing and
wash it before reuse.