High Stability Gyro - Manual

Instruction
Switch1:servo types setting, turn to ONKE for digital, the other side for simulation
Switch2:sensitivity forward and reverse setting , change gyroscope sensitivity
correspond to servo action.
LED
when power it on, fast blink means initializing gyroscope midpoint and the remote
control direction midpoint. Don’t move the gyroscope or change the remote control
direction. If LED stops blinking and constantly light after initialization, means
receiving sensitivity digital, sensitivity is set by remote control, the potentiometer
can adjust the range that the servo output, clockwise up. If LED blinks slowly when
initialization completed, means no sensitivity digital received, the sensitivity is set
by potentiometer, clockwise shows the maximum, the servo is at the maximum
range meantime.
142mm*210mm
ONI2801