User's Manual

Onity HT24W / HT28 Smart Hardware • 103
• Press and hold the ‘Exit’ button for 5 seconds to enter the setup menu.
• Arrow down to ‘Card Tech. #1’ and press ‘Enter’
• Select ‘Prox.’ and press enter
• Arrow down to ‘Card Tech. #2’ and press ‘Enter’
• Select ‘CLR=None’ and press ‘Enter’
• Press the ‘Exit’ button to leave the setup menu
The encoder is now setup for proximity encoding only. If you are using a computer
based system, you should select proximity only for your card technology.
Encoding Keys
Refer to your system user manual for detailed instructions on encoding, as this
manual only deals with the actual presenting of the key to the encoder.
Magnetic Stripe Encoding (HT22iP only, HT Proximity Only)
When prompted for magnetic stripe encoding, insert the keycard into the slot of the
encoder, then remove the keycard. If an error occurs, the encoder will beep and
display the error message. If the encoding is valid, no error beep is given and the
card is ready for use.
Proximity Encoding
When prompted for proximity encoding, present the proximity card or token to the
Prox Logo on the encoder. When the encoder is ready to encode a proximity key, it
will begin to beep. Present the card at the logo point shown below. The encoder will
emit a louder beep when the encoding has been completed.