User's Manual

ManualsBrandsOnity ManualsElectronicsRFID TRANSMITTER

131

132

133

134

135

136

137

138

139

140

Onity HT24W / HT28 Smart Appendix A – Certifications • 133

that to which the receiver is connected. —Consult the dealer or an experienced radio/TV

technician for help.

This device complies with Industry Canada license-exempt RSS standard(s). Operation is

subject to the following two conditions: (1) this device may not cause interference, and (2)

this device must accept any interference, including interference that my cause undesired

operation of the device

HT RFID

CERTIFICATIONS

Federal Communications Commission

FCC ID: R32-HTRFIDMFR01

Industry Canada

IC ID: 5058A- HTRFIDMFR01

USER INFORMATION FOR RF DEVICES

Part 15 - §15.21

Changes or modifications not expressly approved by the party responsible for compliance

could void the user's authority to operate the equipment.

Part 15 - Class A digital device or peripheral§15.105(a)

This equipment has been tested and found to comply with the limits for a Class A digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference when the equipment is operated in a

commercial environment. This equipment generates, uses, and can radiate radio frequency

energy and, if not installed and used in accordance with the instruction manual, may cause

harmful interference to radio communications. Operation of this equipment in a residential

area is likely to cause harmful interference in which case the user will be required to correct

the interference at his own expense.

Part 15 - Class B digital device or peripheral§15.105(b)

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user

is encouraged to try to correct the interference by one or more of the following measures:

—Reorient or relocate the receiving antenna. —Increase the separation between the

equipment and receiver. —Connect the equipment into an outlet on a circuit different from