Instruction manual

29
En
You can select to output sound from Speakers A,
Speakers B, or both A + B.
Note
• While headphones are connected, this setting is disabled.
•When “ROUTE” is set to “PRE”, this setting is disabled
(➔ page 39).
• When this setting is set to A + B, the impedance of speakers is
restricted. For further details, see “Connecting Your Speakers”
(➔ page 15).
You can adjust the volume within the following range:
VOLMIN, -95dB, -90dB, -85dB, -80dB to 14dB,
VOLMAX
■ Operating with the remote controller
■ Operating on the integrated amplifier
Tip
• The default level is -55 dB.
You can switch inputs to select the desired source
component. Choose an input from the following:
LINE1, LINE2, LINE3, COAX1, COAX2, OPT,
AES-EBU, USB, PHONO
■ Operating with the remote controller
■ Operating on the integrated amplifier
Tip
• For changing the input’s name, see “Changing Input Names”
(➔ page 36).
• To hide the display of unused inputs, see “Skipping Unused
Inputs” (➔ page 37).
Note
• If there is no USB connection, “USB” is not displayed.
Selecting Speakers A and Speakers B
1
Press SPEAKERS repeatedly on the integrated
amplifier.
The LED of the selected speakers lights.
SPEAKERS A B
Adjusting the Volume
1
Press VOLUME q/w repeatedly.
1
Use the volume controller.
VOLUME q/w
Volume controller
Selecting the Input Source
1
Press INPUT!/" repeatedly.
1
Use the INPUT selector.
INPUT !/"
INPUT selector