Instruction manual

Connections
En-8
Connecting a turntable
Using an audio pin cable, connect to the PHONO (MM)
terminal. Also, if there is a GND terminal on the turntable,
connect with the GND terminal of this unit using a ground
wire.
0 This unit is designed for a turntable using a MM
cartridge. When using a turntable with MC cartridge,
connect a commercial step-up transformer or head
amplifier between this unit and the turntable.
0 When the turntable has a built-in phono equalizer,
connect the audio pin cable to one of the LINE IN 1/2/
3/4 terminal.
Connecting Onkyo equipment with RI terminal
Following link functions can be operated by connecting
an Onkyo CD player, an RI dock, or a tuner (*) with RI
terminal via an RI cable.
*
The link function will not operate appropriately with other
equipment such as MD player, etc. Also, part of the function
may not operate even if it is connected via RI depending on the
equipment.
Auto Power On: When you start playback on an
equipment connected via RI while the unit is in standby
mode, the unit will automatically turn on and select that
equipment as the input source.
Direct Change: When playback is started on an
equipment connected via RI, the unit automatically
selects that equipment as the input source.
System Off: When you turn off the unit, the equipment
turn off automatically.
Remote Control: You can use the unit’s remote control
to control your other RI-capable Onkyo equipment,
pointing the remote control at the unit’s remote control
sensor instead of the equipment.
For information on remote control operation, see
“Operating with the remote control” (> 13).
Connection example (connection to a CD
player via LINE)
This is an example of connecting Onkyo CD player via
LINE. See next section for other connections.
1. Connect the audio pin cable to the LINE IN 1 jack.
0 The RI link will not work properly when connected to
a terminal other than the LINE IN 1.
2. Connect the RI cable to the REMOTE CONTROL
jack.
0 When there are two RI terminals on the used
equipment, the operation is the same when
connected to either terminal.
3. (North American and Continental European models)
Set the RI MODE (CD) switch to LINE1.
A-9010_eng.book 8 ページ ２０１４年１２月２５日 木曜日 午前１０時４８分