User Guide
18
En
This unit is compatible with turntables using either MM
cartridges or MC cartridges. You will need to switch the
input setting to match the type of cartridge you are using.
Refer to “Changing the input setting from a turntable to
MC” (
Ä page 27
) for how to switch.
Note
• Keep the shorting pin in a safe place.
• Do not insert the shorting pin in any jacks other than the
PHONO (MM/MC) L/R jack. Doing so may cause the unit to
malfunction.
Tip
• If the turntable has a ground wire, connect it to GND terminal.
With some turntables, connecting the ground wire may cause
hum, in which case it should be disconnected.
• If your turntable has a built-in phono preamp, connect to
other analog inputs such as
LINE IN
.
Tip
• Connect your cassette tape deck to either of the following jacks:
LINE IN 1/2/3/4.
Note
• Volume adjustments and use of the muting function are not
reflected in the signal output from LINE OUT.
• Manual tone adjustments using the BASS –/+ controller,
TREBLE –/+ controller, BALANCE L/R controller, direct
function, and phase matching bass function are not reflected in
the signal output from LINE OUT.
• See the manual of the recording component for instructions on
correct use.
Connecting a Turntable
1
Use an analog audio cable to connect the PHONO
(MM/MC) L/R jacks to the audio output jacks on the
turntable, as shown.
A shorting pin has been inserted in the
PHONO
(MM/MC) L/R
jack. Remove the shorting pin to connect.
Connecting a Cassette Tape Deck
L
R
AUDIO
OUTPUT
Ground wire
Integrated Amplifier
AUDIO
OUT
LR
Integrated Amplifier
Cassette tape deck
Connecting a Recording Component
Important:
• Unless you have the full consent of the copyright holder,
copyright laws prohibit using your recordings for anything
other than personal enjoyment!
• Do not change the integrated amplifier’s input while
recording. Doing so will cause the audio from the selected
component to be recorded.
AUDIO
IN
LR
Integrated Amplifier
Cassette tape deck
SN29402928A_A-9150_En_1704XX.book 18 ページ ２０１７年５月１８日 木曜日 午後５時５分