User Guide

19
En
The integrated amplifier can be used as a preamplifier (Pre
mode). This is an example of connection using the power
amplifier.
The integrated amplifier can be used as a power amplifier.
This is an example of connection using the Onkyo pre-
amplifier (sold separately). Only the MAIN IN jacks and
SPEAKERS jacks are used.
Tip
• Do not connect a source device (CD device, etc.) to the MAIN
IN jack. Doing so may produce high-volume sound that can
damage the unit, speakers, and various other devices.
• When this unit is to be used as a power amplifier, "Adjusting the
Bass, Treble and Balance" (Ä page 24) and “Using the
PHASE MATCHING BASS Function” (Ä page 23) are not
available. Headphones (Ä page 24) also cannot be used.
• Adjust the volume on the pre-amplifier as you will not be able to
adjust it on this unit.
• If this unit is being used as a power amplifier and input is
switched to "MAIN IN", then if the volume of the connected pre-
amplifier is low, auto standby (Ä page 25) may function and
the power may automatically switch to standby. If this happens,
you may be able to fix it by increasing the volume on the pre-
amplifier.
Using the Integrated Amplifier as a
Preamplifier
Integrated Amplifier
Power Amplifier
Using the Integrated Amplifier as a
Power Amplifier
1
Connect an RCA cable to the MAIN IN jacks.
Refer to “Connecting Your Speakers” (
Ä page 12 )
for how to connect speakers.
2
After all connections are complete, turn on the
power ( Ä page 21 ).
3
Turn the INPUT dial to change the input source to
"MAIN IN" (
Ä page 23 ).
The MAIN IN LED flashes.
4
Press DIRECT or ENTER on the remote
controller.
The MAIN IN LED lights.
Integrated Amplifier
Preamplifier
SN29402928A_A-9150_En_1704XX.book 19 ページ ２０１７年５月１８日 木曜日 午後５時５分