User Guide

25
En
Advanced Operations
Custom Setup
When the Auto Standby (ASb) function is activated, the
integrated amplifier will automatically enter Standby
mode if there is no operation for 20 minutes with no audio
signal input (Default value: "Off" for North American
models, "On" for Other Countries).
You can set the impedance of the speakers that you
connect to the unit (Default value is "8 Ω").
Setting the Auto Standby Function
1
Switch the AUTO STANDBY selector on the unit’s
rear panel.
1
[ON]
Enables auto standby.
1
[OFF]
Disables auto standby.
AUTO STANDBY selector
Setting the speaker impedance
1
Press SETUP on the remote controller.
SETUP does not work when MAIN IN input is
selected. Select an input other than MAIN IN to
operate.
2
Press
D
/
C
on the remote controller so the "D1" to
"D4" and "LINE1" to "LINE4" LEDs flash.
3
Press
B/A
on the remote controller to switch the
impedance.
The flashing of the input source LEDs changes each
time you change the setting.
When using speakers with impedance of
4 Ω or more to less than 8 Ω
Make it so only the "D1" to "D4" LEDs are flashing.
When using speakers with impedance of
8 Ω or more to less than 16 Ω
Make it so the "D1" to "D4" and "LINE1" to
"LINE4" LEDs are flashing.
4
Press SETUP on the remote controller.
D/C/B/A
SETUP
D1 to D4 LED
D1 to D4 and LINE1 to LINE4 LED
SN29402928A_A-9150_En_1704XX.book 25 ページ 2017年5月18日 木曜日 午後5時5