User Guide

26
En
By connecting an Onkyo component with jack to the
unit by using an cable and a digital cable or an RCA
cable, you can link the unit's power and input selection
and enable operation with this unit's remote controller (*).
After connecting the unit and the Onkyo component with
a digital cable or RCA cable (
Ä page 15 to 17 ), perform
the following operations.
A connection to the jack is not enough for the units to
operate as a system. The units must also be connect
properly by a digital cable or an RCA cable.
Refer to “Remote Controller” ( Ä page 10 ) for operation
of connected devices.
Note
• cables can be connected in any order.
• Some functions may not be supported depending on the
product even when an connection is used.
• The feature on this unit supports Onkyo CD players,
tuners, network audio players, and docks only. It does
not work properly with other devices such as MD
recorders.
• Only auto-power on and direct change are supported for
CD players.
• Refer to the instruction manual of the component with the
jack for details.
* With (Remote Interactive), you can use the
following special functions:
∫Auto Power On
When you start playback on a component connected via
while the integrated amplifier is on Standby, the
integrated amplifier will automatically turn on and
select that component as the input source.
∫Direct Change
When playback is started on a component connected via
, the integrated amplifier automatically selects that
component as the input source.
∫System Off
When you turn off the integrated amplifier, the
components turn off automatically.
Connecting with Onkyo RI
Components
1
Connect the cable.
When there are two jacks, both jacks work in the
same way. You can connect either one.
2
Press SETUP on the remote controller.
SETUP does not work when MAIN IN input is
selected. Select an input other than MAIN IN to
operate.
3
Repeatedly press D / C on the remote controller.
1 When linking with a CD player
Select so that D1 and LINE 1 light (or flash).
1 When linking with a tuner
Select so that D2 and LINE 2 light (or flash).
1 When linking with a dock or network
audio player
Select so that D3 and LINE 3 light (or flash).
CD Player
D/C/B/A
SETUP
4
Press B/A on the remote controller to select the
jack to use for linking.
The flashing of the input source LEDs changes each
time you change the setting.
1 When linking with a CD player
When connected to the D1 jack, make it so only
the "D1" LED is flashing (the default value is
"D1"). When connected to the LINE 1 jack,
make it so only the "LINE 1" LED is flashing.
1 When linking with a tuner
When connected to the D2 jack, make it so only
the "D2" LED is flashing (the default value is
"D2"). When connected to the LINE 2 jack,
make it so only the "LINE 2" LED is flashing.
1 When linking with a dock or network
audio player
When connected to the D3 jack, make it so only
the "D3" LED is flashing (the default value is
"D3"). When connected to the LINE 3 jack,
make it so only the "LINE 3" LED is flashing.
5
Press SETUP on the remote controller.
SN29402928A_A-9150_En_1704XX.book 26 ページ ２０１７年５月１８日 木曜日 午後５時５分