CP-1050 Direct Drive Turntable Instruction Manual Names and functions of parts ..... 6 Assembly and installation............ 7 Preparatory adjustments ............. 8 1. Horizontal balance............................ 8 2. Stylus pressure .................................9 3. Anti-skating.......................................9 Connections .............................. 10 Playing records ......................... 11 Thank you for purchasing an Onkyo product.
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPARATUS TO RAIN OR MOISTURE. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USERSERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
Precautions 1. Recording Copyright—Unless it’s for personal use only, recording copyrighted material is illegal without the permission of the copyright holder. 2. AC Fuse—The AC fuse inside the unit is not userserviceable. If you cannot turn on the unit, contact your Onkyo dealer. 3. Care—Occasionally you should dust the unit all over with a soft cloth. For stubborn stains, use a soft cloth dampened with a weak solution of mild detergent and water. Dry the unit immediately afterwards with a clean cloth.
Precautions For U.S. and Canadian models FCC CAUTION Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Features Supplied accessories Professional manual record player with a focus on sound quality Before use, check whether the main unit and the accessories below are supplied. This is a manual player with simple functions that is designed with the highest priority placed on the sound quality for playing analog records. In terms of operations, usability is ensured with fittings such as a lifter for lowering and raising the tone arm. Also, the cartridge and head shell can be replaced.
Names and functions of parts POWER button ( ON/ OFF): Press this button to turn the unit on or off. Speed selector button (33/45): Set this button according to the record’s playing speed. Center spindle Rubber mat Turntable Counterweight: Use this to balance the tone arm and to adjust the stylus pressure. Head shell 6 START/STOP button: Rotates/stops the turntable. Locking nut: Use this to install the head shell. Tone arm Arm clamp: Secures the tone arm to the arm rest.
Assembly and installation 3. Mounting the counterweight Assembly 1. Mounting the turntable and rubber mat Mount the counterweight on the shaft at the back of the tone arm. 0 Do not rotate the counterweight to a position where the white center line on the shaft at the back of the tone arm is no longer visible. 1. Insert the turntable onto the center spindle. 0 Handle the turntable with care so that it does not drop onto or hit the unit, tone arm, etc. 2. Lay the rubber mat on top.
Preparatory adjustments 3. Release the arm clamp. Handling the stylus The tip of the stylus is extremely delicate. Be careful not to break or bend the stylus when removing the stylus cover. If the stylus tip is damaged, promptly replace it with a new stylus. If a damaged stylus is used, it will result in damage to the record. 1. Horizontal balance The horizontal balance of the tone arm needs to be adjusted first in order to ensure that an appropriate stylus pressure is applied on the record.
Preparatory adjustments 2. Stylus pressure First turn the scale of the stylus pressure temporarily to “0” in a horizontally balanced state, and then adjust the stylus pressure. If the stylus pressure is too high or too low, the record may not be played back correctly, or the stylus life may be shortened, or the record may be damaged. Be sure to adjust the stylus pressure to an appropriate value to match the cartridge. 2.
Connections Amplifier to an AC outlet 1. Connection with the amplifier 3. Mounting the dust cover Connect the supplied pin cables with attached grounding to the PHONO OUTPUT terminals on the rear panel of the unit and the PHONO input terminals of the amplifier. Connect the red plug to the R terminal and the white plug to the L terminal respectively.
Playing records Before playing the music 0 Release the arm clamp. 0 Turn on the power supply of the connected amplifier and switch the input so that the sound of this unit comes out. Keep the volume of the amplifier low. 5. Raise the lifter lever, hold the head shell’s finger hook, and move the tone arm to the desired position over the record. Lifter lever 6. Lower the lifter lever. The tone arm will slowly descend until the stylus tip touches the record and start playing the music.
Troubleshooting Before starting the procedure Problems may be solved by simply turning the power on/off or disconnecting/connecting the power cord, which is easier than working on the connection, setting and operating procedure. Try the simple measures on both the unit and the connected device. The unit does not turn on. 0 Confirm that the power plug is securely plugged in to an outlet.
Handling Handling and maintenance of stylus Take due care when handling the stylus as the stylus tip is extremely delicate. Remove any dust attached to the stylus tip using a brush with a soft tip by brushing from the base of the stylus towards the end. You can also use a special cleaner available commercially for cleaning. Replacing the stylus The life-span of the stylus is normally about 500 hours but varies greatly depending on the usage conditions.
Specifications ∫ Turntable section Drive method: Turning speed: Wow and flutter: Signal to noise ratio: Turntable: Motor: Starting torque: Direct drive 33 1/3 rpm, 45 rpm 0.15 % or less 60 dB or above Aluminum die-cast Diameter 305 mm Brushless DC motor 1.
Kitahama Chuo Bldg, 2-2-22 Kitahama, Chuo-ku, OSAKA 541-0041, JAPAN http://www.onkyo.com/ The Americas 18 Park Way, Upper Saddle River, N.J. 07458, U.S.A. For Dealer, Service, Order and all other Business Inquiries: Tel: 201-785-2600 Fax: 201-785-2650 http://www.us.onkyo.com/ For Product Support Team Only: 1-800-229-1687 http://www.us.onkyo.com/ Europe Liegnitzerstrasse 6, 82194 Groebenzell, GERMANY Tel: +49-8142-4401-0 Fax: +49-8142-4208-213 http://www.eu.onkyo.