Specifications

43
Listening to the Radio
Tuning into FM/AM Radio Stations
When tuned into a station, the Tuned indicator
appears. When tuned into a stereo FM station, the FM
ST indicator appears as well.
Tuning into weak stereo FM/AM stations
If the signal from a stereo FM station is weak, it may
be impossible to get good reception. In this case,
switch to Manual Tuning mode and listen to the station
in mono.
Adjusting the Antennas
Adjusting and installing the antenna
Choose a location for the antenna while listening to a station.
TUNER
MODE/YES
/
AUTO
FM ST
Band Frequency
1
Press the [TUNER] button repeatedly
to select “FM” or “AM”.
2
Press the [MODE/YES] button
repeatedly to select “Auto” or
“Manual”.
• Auto Tuning Mode
The AUTO indicator appears and stereo
radio reception is possible.
• Manual Tuning Mode
The AUTO indicator is not displayed and
radio reception will be in mono.
3
Use the Fast Reverse and Fast
Forward [ ]/[ ] buttons or [MULTI
JOG] control to tune into a station.
In Auto tuning mode, once a station is
found, tuning stops automatically.
The stereo receiver changes FM frequency
in 0.05 MHz steps, AM frequency in 9kHz.
In Manual Tuning mode, the frequency
stops changing when you release the
button.
Press the button repeatedly to change the
frequency one step at a time.
FM /
DAB (R-1045DAB only)
AM
FM
Change the direction of the antenna to
achieve the best reception.
!
Caution
Be careful not to prick your finger!
DAB (R-1045DAB only)
Affix the antenna with a
thumbtack. (Do not push the
thumbtack through the antenna.)