Manual

Basic Operations
m Operating on the AV receiver
_Use the selector buttons to select the
input input
source.
Start playback on the source component.
See also:
• "Controlling Other Components" (O 51 )
• "Controlling iPod" (_ 47)
• "Listening to the Radio" (_ 24)
To adjust the volume, use the MASTER VOLUME
control.
Select a listening mode and enjoy!
See also:
• "Using the Listening Modes" (_ 28)
• "Audyssey Settings" (_ 37)
N Operating with the remote controller
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii,,,
Press RECEIVER followed by INPUT SELEC-
TOR.
Start playback on tile source component.
See also:
• "Controlling Other Components" (_ 51 )
• "Controlling iPod" (_ 47)
• "Listening to the Radio" (_ 24)
To adjust tile volume, use VOL I/V.
Select a listening mode and enjoy!
See also:
• "Using the Listening Modes" (_ 28)
• "Audyssey Settings" (_ 37)
• When the subwoofer volume level is set to a positive (+) value,
the maximum master volume level is reduced proportionally.
To set the level of the subwoofer, use the OUTPUT
LEVEL control.
Because our ears are less sensitive to very low bass
sounds, there's a temptation to set the level of the sub-
woofer too high. As a rule of thumb, set the subwoofer
level to what you think is the optimal level, and then back
it off slightly.
You can display various information about the current
input source as follows. (Components connected to the
UNIVERSAL PORT jack are excluded.)
Press RECEIVER followed by DISPLAY repeat-
edly to cycle through the available information.
• Alternatively, you call use the AV receiver's DISPLAY.
The following information can typically be displayed.
Input source & /
volume*l i::?J_ ...i_ ./i i"_ ,:.i.:.=?
1
Signal format*2 ]
or sampling fre- il)C .Z_i:,?, i) _:.:},, .i
quency
Input source &
listening mode*3 ,....,...i:::."-"
1
"1 When AM or FM radio is used, the baud, preset number, and
frequency are displayed.
*2 [f the input signal is analog, no format information is dis-
played. If the input signal is PCM, the sampling frequency is
displayed. [fthe input signal is digital but not PCM, the signal
format is displayed.
[nformatiou is displayed for about three seconds, then the pre-
viously displayed information reappears.
*3 The input source is displayed with the default name even
when you have selected a name in "Name Edit" (_ 39).
The Music Optimizer function enhances the sound quality
of compressed music tiles.
Press MUSIC OPTIMIZER on the front panel.
The M.Opt indicator lights on the display.
• Alteruatively, you can use the remote controller's AUDIO and
arrow buttons.
• See "Music Optimizer" for more details (_ 42).
You can adjust the brightness of the AV receiver's display.
Press RECEIVER followed by DIMMER repeat-
edly to select: dim, dimmer, or normal brightness.
Erl
22
• Alteruatively, you can use the AV receiver's DIMMER (North
American models).