Manual

• When you connect to both AUX INPUT AUDIO `jacks and AUX INPUT LINE IN `jack at the same time, AUX INPUT LINE IN `jack

will be given a higher priority.

• The AV receiver can output audio and video signals from the AUX INPUT jacks to the VCR/DVR OUT jacks.

Step 1:

Make sure that each Onkyo component is connected

with an analog audio cable (connection _ in the hookup

examples) (_ 17).

Step 2:

Make the R I connection (see illustration below).

Step 3:

If you're using an RI Dock, or cassette tape deck,

change the Input Display (_ 23).

With R I (Remote Interactive), you can use the following

special functions:

N System On/Auto Power On

When you start playback on a component connected via

f-4I, if the AV receiver is on Standby, it will automati-

cally turn on and select that component as the input

source.

N Direct Change

When playback is started on a component connected via

if4 I, the AV receiver automatically selects that compo-

nent as the input source.

N Remote Control

You can use the AV receiver's remote controller to con-

trol your other f-4I-capable Onkyo components, point-

ing the remote controller at the AV receiver's remote

control sensor instead of the component. You must enter

the appropriate remote control code first (_ 51 ).

• Use only 1"-41cables for 1"-41connections. 1"-41cables are supplied

with Onkyo players (DVD, CD, etc.).

• Some components have two 1"-41`jacks. You can connect either

one to the AV receiver. The other,jack is for connecting addi-

tional 1"-4I-capable components.

• Connect only Onkyo components to 1"-41`jacks. Connecting other

manufacturer's components may cause a malfunction.

• Some components may not support all 1"-41functions. Refer to

the manuals supplied with your other Onkyo components.

• While Zone 2 is on, the System On/Auto Power On and Direct

Change 141 functions do not work.

e,g,, CD player I

.- __.j I

e,g,, DVD player