Manual

rv_g!m,_NN_
You can enter a preset name for each individual input
selector for easy identification. When entered, the preset
name will appear on the display.
Preparation
Press the input selector buttons to select an input source.
m Name
- - -, Blu-ray, DVD, HD DVD, VCR, DVR, Tivo,
CahleSTB, SAT STB, PS3, Wii, Xhox, PC, TV, CD,
TAPE, iPod:
To reset to the default, select "- - -".
• Can not set the input selector by the same name.
• This menu cannot be used for the TUNER input selector.
Speaker Settings
If the impedance of any speaker is 4 ohms or more but less
than 6, set the minimum speaker impedance to 4 ohms.
• Before you change these settings, turn down the volume.
N Sp Impedance
4ohms:
Select if the impedance of any speaker is 4 ohms or
more but less than 6.
6ohms:
Select if the impedances of all speakers are between
6 and 16 ohms.
• (North American models) Do not support speakers with an
impedance of less than 6 ohms.
N Front High/Zone2
Front High:
Front high speakers can be used.
Zone2:
Zone2 speakers can be used.
Select "Zone2" if you've connected your Zone 2 speakers
to FRONT HIGH OR ZONE 2 SPEAKERS L/R termi-
nals (_ 44).
I SurrBk/FrontHigh
Front High:
Front high speakers can be used.
SurrBack:
Surround back speakers can be used.
Select "Front High" if you've connected your Zone 2
speakers to FRONT HIGH OR ZONE 2 SPEAKERS L/
R terminals, and the front high speakers to SURR BACK
OR FRONT HIGH SPEAKERS L/R terminals.
!
• If the "Front High/Zone2" setting is set to "Front High", this
setting is set to "SurrBack".
Remote Control Settings
m Remote ID
_1,2, or3
When several Onkyo components are used in the same
room, their remote ID codes may overlap. To differenti-
ate the AV receiver from the other components, you can
change its remote ID from 'T', to "2" or "3".
• If you do change the AV receiver's remote [D, be sure to change
the remote controller to the same [D (see below), otherwise, you
won't be able to control it with the remote controller.
Changing the Remote Controller's ID
While holding down RECEIVER, press and hold
down SETUP until the remote indicator lights
....................................(about 3 seconds).
Use the number buttons to enter ID 1, 2, or 3.
The remote indicator flashes twice.
FM/AM Frequency Setup Settings
For FM/AM tuning to work properly, you must specify the
FM/AM frequency step used in your area. Note that when
this setting is changed, all radio presets will be deleted.
m FM/AM Freq Step (North American models)
200k/10kHz:
Select if 200 k/l 0 kHz steps are used in your area.
50k/9kHz:
Select if 50 k/9 kHz steps are used in your area.
m AM Freq Step (Asian models)
10kHz:
Select if 10 kHz steps are used in your area.
9kHz:
Select if 9 kHz steps areused in your area.
i /
E[3
39