Manual

Controlling Other Components
You can use the AV receiver's remote controller
(RC-764M) to control your other AV components. This
section explains how to enter the remote control code
(with the default underlined) for a component that you
want to control: DVD, TV, CD, etc.
Onkyo components that are connected via r41 are con-
trolled by pointing the remote controller at the AV
receiver, not the component. This allows you to control
components that are out of view, in a rack, for example.
The following REMOTE MODE are preprogrammed
with remote control codes for controlling the components
listed. You do not need to enter a remote control code to
control these components.
For details on controlling these components, see the pages
indicated.
BD/DVD Onkyo Blu-ray Disc player (_ 52)
TWCD Onkyo CD player (_ 52)
PORT Onkyo Universal Port Option (_ 49)
You'll need to enter a code for each component that you
want to control.
Look the control code in
appropriate
up
remote
I:!_ the separate Remote Control Codes list.
....................................The codes are organized by category (e.g., DVD
_ player, TV_ etc.).
While holding down REMOTE MODE to which
you want to enter a code, press and hold down
DISPLAY until the remote indicator lights (about
3 seconds).
!
• Remote control codes cannot be entered for RECEIVER
and ZONE 2.
• Only TV remote control codes call be entered for TV.
• Apart from RECEIVER, TV, and ZONE 2, remote con-
trol codes from any category can be entered for REMOTE
MODE. However, these buttons also work as input selec-
tor buttons (_ 22), so choose a REMOTE MODE that
corresponds with the input to which you connect your
component. For example, if you connect your CD player
to the CD input, choose TV/CD when entering its remote
_ control code.
Within 30 seconds, use the number buttons to
enter the 5-digit remote control code.
The remote indicator flashes twice.
If the remote control code is not entered success-
fully, the remote indicator will flash once slowly.
Make sure the Onkyo component is connected
with an f:_I cable and an analog audio cable
(RCA).
See "Connecting Onkyo f'41 Components" for
details (_ 18).
Enter the appropriate remote control code for
REMOTEMODE.
• BD/DVD
31612:
Onkyo DVD player with f'4 I
• TV/CD
71327:
Onkyo CD player with RI
42157:
Onkyo cassette tape deck with R I
• PORT
_81993:
Onkyo Dock
See the previous section for how to enter remote
control codes.
• When using a cassette tape deck connected via RI, press
and hold TWCD to switch to TAPE.
Press REMOTE MODE, point the remote control-
ler at the AV receiver, and operate the component.
If you want to control an Onkyo component by pointing
the remote controller directly at it, or you want to control
an Onkyo component that's not connected via f-4I, use the
following remote control codes:
• BD/DVD
30627:
Onkyo DVD player without f:_I
• TWCD
71817:
Onkyo CD player without R I
11807:
Onkyo TV
En
51