Manual

If you want to control an Onkyo component by pointing the
remote controller directly at it, use the following remote
control codes:
32900:
Onkyo Blu-ray Disc player
32901:
Onkyo HD-DVD player
70868:
Onkyo MD recorder
71323:
Onkyo CD recorder
82990:
Onkyo Dock
• If you connect an cassette tape deck to the TV/CD IN jack, or
connect all R[ Dock to the TWCD IN or VCR/DVR IN or
GAME INjacks, for 1"-41to work properly, you must set the Input
Display accordingly (_ 23).
By pressing REMOTE MODE that's been programmed
with the remote control code for your component, you can
control your component as below.
For details on entering a remote control code for a differ-
ent component (_ 51 ).
Controlling a Blu-ray Disc/DVD Player, HD
DVD Player or DVD Recorder
BD/DVD is preprogrammed with the remote control code
for controlling a component that supports the I-'4AI-ID.
The component must be able to receive remote control
commands via f-'4Jl-lD and be connected to the AV
receiver via HDMI.
You can reset a REMOTE MODE to its default remote
control code.
While holding down REMOTE MODE that you
want to reset, press and hold down AUDIO until
the remote indicator lights (about 3 seconds).
Within 30 seconds, press REMOTE MODE again.
The remote indicator flashes twice, indicating that
the button has been reset.
Each of REMOTE MODE is preprogrammed with a
remote control code. When a button is reset, its pre-
....................................programmed code is restored.
= " " O " = " • " • • "
You can reset the remote controller to its default settings.
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
While holding down RECEIVER, press and hold
down AUDIO until the remote indicator lights
(about 3 seconds).
Within 30 seconds, press RECEIVER again.
The remote indicator flashes twice, indicating that
the remote controller has been reset.
En
52