Manual

Troubleshooting
If you have any trouble using the AV receiver, look for a
solution in this section. If you can't resolve the issue your-
self, contact your Onkyo dealer.
If you can't resolve the issue yourself, try resetting the
AV receiver before contacting your Onkyo dealer.
To reset tile AV receiver to its factory defaults, turn it
on and, while holding down VCB/DVB, press ON/
STAN DBY. "Clear" will appear on the display and
the AV receiver will enter Standby mode.
VCR/DVR
I/o oN,s FAN£BY
_rtt_/t;l
Note that resetting the AV receiver will delete your
radio presets and custom settings.
Remote indicator
RECEIVER
AUDIO
To reset the remote controller to its factory defaults,
while holding down RECEIVER, press and hold down
AUDIO until the remote indicator lights (about 3 sec-
onds). Within 30 seconds, press RECEIVER
again.
m The STANDBY indicator flashes red
The protection circuit has been activated. Remove
the power cord from the wall outlet immediately.
Disconnect all speaker cables and input sources, and
leave the AV receiver with its power cord discon-
nected for 1 hour. After that, reconnect the power
cord and set the volume to maximum. If the AV
receiver stays on, set the volume to minimum, dis-
connect the power cord, and reconnect your speakers
and input sources. If the AV receiver turns off when
you set the volume to maximum, disconnect the
power cord, and contact your Onkyo dealer.
N There's no sound, or it's very quiet
Make sure that tile digital input source is selected
properly.
Make sure that the inputs and outputs of all compo-
nents are connected properly.
34
Make sure that the input source is properly selected. 22
Check the volume. The AV receiver is designed for
home theater enjoyment. It has a wide volume range,
allowing precise adjustment.
If there's no sound from a DVD player connected to
an HDM[ IN, check the DVD player's output set-
tings, and be sure to select a supported audio format.
With some DVD-Video discs, you need to select an
audio output format from a menu.
Make sure that none of the connecting cables are
bent, twisted, or damaged.
16-18
r_
N Can't turn on the AV receiver
Make sure that tile pow'er cord is properly plugged
into the wall outlet.
Specify the speaker distances and adjust the individ- 36
ual speaker levels.
The input signal format is set to PCM or DTS. Set it 43
to Auto.
N Only the front speakers produce sound
When the Stereo or Mono listening mode is selected, --
only the front speakers and subwoofer produce
sound.
@
ED
54