Manual

m The AV receiver unexpectedly selects your iPod
as the input source
Always pause iPod playback before selecting a dif-
ferent input source, ff playback is not paused, the
Direct Change function may select your iPod as the
input source by mistake during the transition
between tracks.
m Can't record
On your recorder, make sure the correct input is
selected.
P_O/FLIN
m There's no sound
Only components connected to analog inputs can be --
played in Zone 2.
N The sound changes when Iconnect my
headphones
When a pair of headphones is connected, the listen-
ing mode is set to Stereo, unless it's already set to
Stereo, Mono, or Direct.
N How do I change the language of a multiplex
source
Use the "Multiplex" setting on the "Audio Adjust" 36
menu to select "Main" or "Sub".
N The 1-41functions don't work
To use f-'_l, you must make an RI connection and an 18
analog audio connection (RCA) between the compo-
nent and AV receiver, even if they are connected dig-
itally.
N The functions Auto Power On/Standby and
Direct Change don't work for components
connected via 1-41
These functions don't work when Zone 2 is turned --
on,
N The following settings can be made for the
composite video inputs
You must use the buttons on the unit to make these set-
tings.
1. While holding down the input selector button for the input
sourcethat you want to set, press SETUP.
2. Use -.41_ to change the setting.
3. Press the input selectorbutton for the input source that you
want to set when you've finished.
• Video Attenuation
This setting can be made for the BD/DVD, VCR/DVR,
CBL/SAT, GAME, or AUX input.
If you have a games console connected to the composite
video input, and the picture isn't very clear, you can
attenuate the gain.
Video ATT:OFF: (default).
Video ATT:ON: Gain is reduced by 2 dB.
The AV receiver contains a microcomputer for signal
processing and control functions. In very rare situations,
severe interference, noise from an external source, or
static electricity may cause it to lockup. In the unlikely
event that this happens, unplug the power cord from the
wall outlet, wait at least live seconds, and then plug it
back in again.
Onkyo is not responsible for damages (such as CD
rental tees) due to unsuccessful recordings caused by
the unit's malfunction. Before you record important
data, make sure that the material will be recorded cor-
rectly.
Before disconnecting the power cord from the wall out-
let, set the AV receiver to Standby.
En
57