Speaker System User Manual
Table Of Contents
- A. When the power-supply cord or plug is damaged,
- B. If liquid has been spilled, or objects have fallen into the apparatus,
- C. If the apparatus has been exposed to rain or water,
- D. If the apparatus does not operate normally by following the operating instructions. Adjust onl...
- E. If the apparatus has been dropped or damaged in any way, and
- F. When the apparatus exhibits a distinct change in performance this indicates a need for service.
- Features
- Getting to Know the HTX-22HD
- Remote Controller
- Connecting the Speakers
- Connecting AV Components
- Turning On the HTX-22HD
- First Time Setup
- Playing Your Components
- Using the Listening Modes
- Advanced Setup
- Troubleshooting
- Specifications
20
Connecting the Speakers
—Continued
For 7.1-channel surround sound, in addition to the 5.1 speakers shown in the hookup diagram on
page 19, you’ll need a pair of surround back speakers and a power amp to drive them. Using an
RCA audio cable, connect the HTX-22HD’s SURROUND BACK PRE OUT jacks to the audio
input on the power amp, as shown below.
Note:
• If you’re using only one surround back speaker, connect it to the SURROUND BACK PRE
OUT L jack.
Connecting Surround Back Speakers
AUDIO INPUT
Surround
back right
speaker
Surround
back left
speaker
Power amp
HTX-22HD_En.book Page 20 Monday, April 7, 2008 2:03 PM