Speaker System User Manual
Table Of Contents
- A. When the power-supply cord or plug is damaged,
- B. If liquid has been spilled, or objects have fallen into the apparatus,
- C. If the apparatus has been exposed to rain or water,
- D. If the apparatus does not operate normally by following the operating instructions. Adjust onl...
- E. If the apparatus has been dropped or damaged in any way, and
- F. When the apparatus exhibits a distinct change in performance this indicates a need for service.
- Features
- Getting to Know the HTX-22HD
- Remote Controller
- Connecting the Speakers
- Connecting AV Components
- Turning On the HTX-22HD
- First Time Setup
- Playing Your Components
- Using the Listening Modes
- Advanced Setup
- Troubleshooting
- Specifications
35
First Time Setup
—Continued
Error Messages
While the automatic speaker setup is in
progress, one of the following error messages
may appear:
❑
Ambient noise is too high
This message appears if there’s too much
background noise and the measurements can-
not be performed properly. Remove the
source of the noise and try again.
❑
Speaker Detect Errors
This message appears if one of the speaker-
related errors below occurs.
• One of the front speakers has not been
detected.
• One of the surround speakers has not been
detected.
• The surround back speakers have been
detected but the surround speakers haven’t.
• The right surround back speaker has been
detected but the left surround back speaker
hasn’t.
There is a problem with a speaker. One of the
speakers is damaged, or the subwoofer is out-
putting sound at the upper end of its range
that is too loud.
❑
Mismatch Error
• The number of speakers detected on the
second or third measurement was different
to the number detected on the first mea-
surement.
This message appears if a speaker that was
detected during the 1st measurement is not
detected during the 2nd or 3rd measurements.
If this message appears, check your speaker
connections, and then try again.
❑
Write Error
This message appears if saving fails.
Changing the Speaker Settings Manually
You can change the settings manually if nec-
essary (see pages 56–62).
To Retry the Automatic Speaker
Setup
Press the [ENTER] button.
Make sure speakers that
cannot be detected are con-
nected properly.
HTX-22HD_En.book Page 35 Monday, April 7, 2008 2:03 PM