User's Manual

23
En
■ There’s no sound, or it’s very quiet
■ The subwoofer produces no sound
■ Noise can be heard
■ The remote controller doesn’t work
■ The controller and the TV operated by
your TV remote controller doesn’t
work
■ Standby power consumption
■ Pairing the controller and the
subwoofer
Audio
Make sure that all audio connecting
plugs are pushed in all the way.
15
Make sure that the input of TV is
connected properly.
15
Make sure that the polarity of the
speaker cables is correct, and that the
bare wires are in contact with the metal
part of each speaker terminal.
14
Make sure that the speaker cables are
not shorting.
14
When the ON/STANDBY LED flashes
white, the muting is enabled. Press
on the remote controller or the
Volume –/+ buttons simultaneously on
the controller to disable the muting.
18
Make sure that none of the connecting
cables are bent, twisted, or damaged.
—
Make sure that there is no obstacle or
reflection between the controller and the
subwoofer.
—
Make sure that the pairing the controller
and the subwoofer completes normally.
—
Using cable ties to bundle audio cables
with power cords, speaker cables, and
the like may degrade the audio
performance, so refrain from doing it.
—
An audio cable may be picking up
interference. Try repositioning your
cables.
—
Remote Controller
Make sure that the battery is installed
with the correct polarity.
8
Make sure that the remote controller is
not too far away from the controller, and
that there’s no obstruction between the
remote controller and the controller’s
remote control sensor.
8
Make sure that the controller is not
subjected to direct sunshine or inverter-
type fluorescent lights. Relocate if
necessary.
—
If the controller is installed in a rack or
cabinet with colored-glass doors, the
remote controller may not work reliably
when the doors are closed.
—
Make sure that the controller mounted
to the wall and the TV set are not placed
too far.
11
Your TV remote controller might not be
compatible with TV remote controller
preprogrammed codes function. If the
ON/STANDBY LED does not flash by
pressing the buttons on your TV remote
controller, use the supplied remote
controller or program the controller. If
the controller cannot be operated with
your remote controller even if the
programming has been performed, the
controller might not recognize your
remote controller. In this case, use the
supplied remote controller.
—
Others
When the Auto Power On function is set
to “on”, the power consumption in ready
mode may reach up to a maximum of
4W.
—
Turn on the controller before performing
a pairing.
1
Press and hold LINK on the rear panel of
the subwoofer for five seconds.
Flashing speed of the LINK LED is
changed.
2
Press and hold 8ON/STANDBY on the
controller for three seconds until the
ON/STANDBY LED flashes white.
The controller and the subwoofer starts
pairing. The ON/STANDBY LED flashes
white twice indicating that the pairing is
completed.
E52_LS3100_120910.book 23 ページ ２０１２年９月１０日 月曜日 午後４時３０分
TENTATIVE